Skip to the record
Mmm.. taste the original NoosaWatch™

Original source · versioned page text

MCU14/0056 Response to SARA - Consulting Report

of 321

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

Very large file: it may take a few minutes

The original of this document is very large (24.7 MB). Opening the original or downloading it may take a few minutes. Please be patient and don't click again. The page text is quick to read. If you are on mobile data, it is best to wait until you are on Wi-Fi.

Original PDF page 119, section 1. The text section number identifies this passage in the reader.

Plans and drawings

This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).

Log in to see the plans as drawn
EN 858-1:2002 (E)

8.3.3 Determination of the nominal size and class

8.3.3.1 Prefabricated separators

8.3.3.1.1 General

The nominal size and corresponding class of each type of separator (see clauses 4 and 5) are determined under
test conditions.

For the test, a model separator made from different materials than the actual product may be used provided that all
dimensions, which may influence the hydraulics, fully conform with those of the actual product.

Only the separator shall be tested, therefore, separators with combined sludge traps shall have the sludge trap
volume excluded. Where .

— the sludge trap is combined and in line with the separator, the volume of the sludge trap shall be excluded by
using a supply pipe or pipes across or through the sludge trap as shown in figure 3a);

— the sludge trap is combined and below the static water tevel of the separator, the volume of the sludge trap
shall be filled with an inert and impermeable material having a smooth surface as shown in figure 3b).

2A This is a licensed reproduction produced by SAI Global Ltd, an authorized distributor of British Standards
Log in to download the original file

MCU14_0056 Response to SARA - Consulting Report.pdf · 24.7 MB (very large file)

Very large file: the download may take a few minutes. If you are on mobile data, it is best to wait until you are on Wi-Fi.

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.