15010_Noosa Council_Decision Notice_221215 · OPW18/0022

                                                                                                       OPW15/0172


                      22.     Any existing unnecessary or redundant property accesses must be removed, and
                              the kerb, footpath and verge area reinstated to match the existing footpath and/or
                              verge treatments. Grassed verge areas to be reinstated must be provided with 100
                              mm topsoil and grass seed or turf, and must be maintained by the developer until
                              established.
                      23.     The following must be complied with during the construction of the required
                              crossover/driveway:
                              a.       The driveway surfacing must consist of either an approved hot mixed
                                       asphaltic concrete or patterned/plain concrete.
                              b.       The driveway must be constructed so as not to concentrate stormwater
                                       runoff onto neighbouring properties
                              c.       Underground service conduits for water supply, electricity and any other
                                       services must be provided as part of the access driveway
                              d.       Where there is an existing pedestrian path, a matching crossfall must be
                                       provided for the driveway on the alignment of the path, for the full width of
                                       the path
                              e.       The property access must be located a minimum of 0.5m clear of existing
                                       power poles, streetlights or other signage. The developer is responsible for
                                       any necessary relocation of existing services to provide this clearance and
                                       must contact the relevant service authorities and comply with their
                                       requirements in relation to these works.
                              Earthworks and Retaining Walls
                      24.     All earthworks shall be undertaken in accordance with the provisions of AS 3798
                              Guidelines on Earthworks for Commercial and Residential Development, with
                              geotechnical testing undertaken in accordance with Section 8 of the Standard, and
                              to a minimum of ‘Level 1’ as defined in Appendix B. Test results as required by AS
                              3798, and a certificate of quality and uniformity of fill shall be provided by a RPEQ
                              and submitted to Council.
                              Stormwater Drainage
                      25.     Appropriate scour protection must be provided at the outlet of all stormwater pipes
                              including temporary outlets.
                      26.     Works associated with this permit must not adversely impact on the existing
                              drainage conditions on other properties (eg by blocking or interfering with natural
                              overland flows).
                      27.     Construction of all internal stormwater drainage works must comply with the
                              relevant section/s of Australian Standard AS/NZS 3500.3.
                              Environment (Erosion and Sediment Control)
                      28.     Prescribed Water Contaminants (as defined in the Environmental Protection Act
                              1994) must not be released from the site or to waters within the site, or be likely to
                              be released should rainfall occur, unless all reasonable and practicable measures
                              are taken to prevent or minimise the release and concentration of contamination.




                                                                                                             Page 6 of 14


Document Set ID: 20003332
Version: 1, Version Date: 22/12/2015                                                               Print Date: 22 December 2015, 3:18 PM