Skip to the record
Noosa's #1 Council Tracker.

Council archive · source document

22441 DA - Response to Information Request [As Published] · 132001.210331.2

of 58

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

3.0

.Job No. CE07/044

PRESENT BUILDING PROPOSAL

Arising out of many discussions and building submissions, data reviews by independent
experts and court appeals and the like, it was agreed that:-

Building on this dune slope was possible with strict controls

Large trees should remain ,

Storm runoff from the house and from the slope should be controlled
Domestic wastewater from the house should be taken to Park Road
Visual Impact should be minimal

The present proposal is the construction of a residence supported by steel screw piles, with a
garage at the toe of the slope.

4.0

41

4.2

DESIGN CONSIDERATIONS

Slope Stability

The overall slope at 30-32° (max) is marginally stable because of the presence of the
trees which have to remain. Piled foundations will provide a minor decrease of the
stability risk but most importantly is the treatment al the toe of the slope with the
garage and construction above.

_ The calculated Factor of Safety for the total face of the dune on No. 10 Park Road for

various slope conditions is given in Table 1 below.

Table 1 — Factor of Safety for Overall Slope

 

 

 

 

 

Slope Treatment Factor of Safety
No trees 0.92
Existing trees 1.0—1,1
With screw piles 1.0 — 1.1 (no change)
With retaining wall and garage at the toe 1.15-4.25"
of the slope

 

 

*Put another way the proposed construction increase the Factor of Safety of
the overall slope by at least 15 percent.

 

 

 

Piles Supports

The support of the proposed residence using screw piles requires penetration below
the very loose sand (say 3m) into the medium dense sand minimum depth of 5 pile
diameters. {f a spiral of 300mm is used, the minimum penetration is 4.5m from the
present ground level. Allowable bearing capacity values are given below that depth.

Table 2 - Base Resistance Screw Piles

 

 

 

 

 

Pile Depth below GL . np . Allowable Bearing Capacity
(m) Equivalent ‘N’ Value at Pile Toe (kPa)
4.5 § 240
5.0 - 13 520
5.5 45 600

 

 

 

 

00979 Kidds & Co Designers : MORRISON GEOTECHNIC

Used in these records

About this file

File size
4.3 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

22441 DA - Response to Information Request [As Published].pdf · 4.3 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.