Skip to the record
Trusted by locals. Built for Noosa.

Council archive · source document

22441 DA - Response to Information Request [As Published] · 132001.210331.2

of 58

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Job No. 203E/194

2.0 FIELD WORK

One borehole was dritled on this allotment in 1981 as part of a previcus investigation for a
residential development, which did not include Park Road access, Two additional boreholes have
been completed to provide design data for the present proposal. :

Boreholes were drilled by hand on the steep slope and the materials encountered (sand only) are
described on the racord sheets in Appendix A.

At each location a dynamic cone penetrometer test (DCP) was carried out as a measure of the

sand density. In this test a 9kg drop weight falling 500mm is used to drive a 30 degree tapered

steel cone having a top diameter of 20mm and fitted to rods of smatlar saclion. For BH1 (1981) ‘
the penetration was measured as drop weight blows for successive penetrations of 150mm. tn

the present (2004) tests, the blow count was recorded for successive penetrations of 100mm.

DGP resulis are included in Appendix A. Test tocations are shown on the site plan.

3.0 RESULTS
3.1. The Site
All three boreholes identified very loose sand from the surface to depths of 2.4m (BH2) to 2.7m .
(BH1) over loose grading to medium dense sand. Borehole BH1 (1981) was continued to a depth
of 14 metres in medium dens sand, Drilling in BH2 and BH3 was discontinued at 4 metres. DCP
tesls in BH2 and BH3 were discontinued at a depth of 6 metres,
4.0 GEOTECHNICAL CONSIDERATIONS
4.1. The Site
This is a very steep sand slope and the upper 2.4m to 2.7m ‘is potenilatly unstable. In an extrame
event If trees were removed, the sand would adopt an angle of repose of about 30 degrees,
similar fo that on exposed dunes in the Noosa areas. A minor unsupported excavation at the toe
of the slape could cause a significant slip.
4.2. The Garage (BH2)
4.2.4, Genera! Comment
Support to the toe of the slope by the garage removes the risk of a major slope failure. This is a
significant and important structure and ils construction must, by necessity, have no impact on the
slope as a whole. Any support wall requiring apen (unsupported) excavation or any construction
involving significant vibrations should be avoided,
A crib block wall, a reinforced earth wall or a sheet pile solution have no application on this sile.

The use of a grout injected pile support is recommended. It Is understood that this solution is part
of the present design. :

10096B Whaley Consulting Group (Robertson) MORRISON GEOTECHNIC

Used in these records

About this file

File size
4.3 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

22441 DA - Response to Information Request [As Published].pdf · 4.3 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.