Skip to the record
NoosaWatch™: The source of truth.

Council archive · source document

09/1382 - Operational Works - Landscaping & Civil Works [As Published] · 142009.1382

of 117

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Very large file (20.7 MB): the whole original can take several minutes to open, especially on a phone. Text is quick to read.

Unit Building, Sunshine Beach

Geotechnical Investigations

3.0 SURFACE CONDITIONS

The site is located on the northeastern side of Elanda Street at Sunshine Beach. The ground surface
across the site slopes to the northeast away from the street frontage at a gradient of about 17%. The
lot has an existing timber framed house with mature trees, gardens and lawns. These will be removed

as part of the development of the site. Low rise unit developments are present on adjacent properties
on three sides.

4.0 SUBSURFACE CONDITIONS

According to the 1:100 000 Geological Series mapping, sheet 9444 and part 9545, prepared by the
Department of Mines and Energy Queenstland, the site is underlain by Pleistocene dunes (mapping unit
Qpd1). These dunes consists of quartz sands in this area.

The subsurface profile was inferred from Coffey'’s boreholes on the site. The soll profile generally
consists of grey silty sand topsoils to depths of 0.3 to 0.4 metres overlying pale grey sands ta the limit of
investigation. The sand strata were generally loose near the surface grading to dense and very dense
with depth.. The loose sand was noted at depths between 0.3 to 0.5 metres near the street frontage
(boreholes BH1 and BH2) but was much deeper, 0.9 to 1.4 metres, at the lower rear part of the site.

Groundwater was not observed in boreholes on the site at the time of fieldwork on 15 January 2008.

5.0 DESIGN CONSIDERATIONS
Shrink Swell

Shrink-swell testing was not undertaken in this instance. Soil reactivity was assessed to be minimal in
tha sandy upper soils on the site.

Differential Settlements

The soils on the site are deep dunal sands. Normally consolidated Clay strata are not anticipated.
Same minor elastic settlements can be anticipated. These are likely to be some 10 to 20 mm
depending on loads and location.

Allowable Bearing Capacity

The allowable bearing capacity is a function of depth and tocation on the site. For high level footings
founded at depths greater than 0.3 metres near the front of the site in the vicinity of boreholes BH1 and
BH2, an allowable bearing capacity of 100 kPa may be adopted for design. For the rear of the site in
the vicinity of boreholes BH3, BH4 and BHS5, the sands are loose to depths of 1.4, 0.9 and 1.1 metres
tespectively. The allowable bearing capacities are low and founding at shallow depth is not
recommended. Deeper footings founded at depths between 1.1 and 1.6 metres is recommended. The
founding strata at these depths are medium dense sands with an allowable bearing capacity of 100
kPa.

Coffey Geotechnics , 2
GEOTKPAR1334AA/A,
22 January 2008

Used in these records

About this file

File size
20.7 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

09_1382 - Operational Works - Landscaping & Civil Works [As Published].pdf · 20.7 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.