F0002-AA007595-AAR-09-SMP · MCU14/0102.05

            3.3        Vacuum removal of Fuel & Silt

            Vacuum the retained oil from both chambers of the SPEL Puraceptor™ and then the silt deposited on the bottom,
            leaving sufficient water to ensure the (auto closure device) ACD remains floating.


            3.4        Vacuum removal of Complete Contents (If Necessary)

            If the quantity of pollutants exceeds recommended level, the complete contents of the Puraceptor™ may need
            to be removed. After full eduction, remove the ACD. Using a pole with a hook, lift out the ACD using the lifting
            eye on the float.


            3.5        Re-insert Coalescer Unit and ACD

            Re-insert the foam coalescer insert into the stainless steel Coalescer unit and re-insert the Coalescer unit into
            the Puraceptor™ as provided with the SPEL lifting/location/locking system. Partially fill the Puraceptor with clean
            water (if necessary) to ensure the ACD when re-inserted remains floating and then re-insert the ACD. Finally
            check the ACD is floating and the retaining cap has been replaced to safeguard against its removal by
            unauthorized persons, unless depth of tank precludes doing so from ground level.


            3.6        SPEL Automatic Alarm/Monitoring System

            The SPEL automatic alarm/monitoring system probe should be lifted out of the probe protection tube, wiped
            clean and re-inserted. The system should now be reset according to instructions.

            All of these Maintenance Processes are illustrated in Figure 16.




HEAD OFFICE                 POSTAL                          EMAIL                           ABN                           spel.com.au
100 Silverwater Road        PO BOX 7138                     [email protected]               83 151 832 629
Silverwater NSW 2128        Silverwater NSW 2128