Original source · versioned page text
Attachment 1 - Stormwater Management Plan
Plans and drawings
This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).
Log in to see the plans as drawn Ocean Protect | OceanGuard Installation Guide
5. Align T-strut onto L-brackets and secure with pop rivets, repeat for second strut
Flow Diverter Install
1. Measure the internal dimensions of the pit at the height at which the plastic is to sit. If necessary
trim flow diverter panels to fit internal dimensions (add an additional 20mm each side to ensure
tight pressure fit)
2. With the plastic bent slightly upwards, lower the Top Section into the pit, guiding the unit so that it
locates on the T Sections struts.
3. Drill a 5mm hole through the flow diverter and into the strut for each T-strut, and secure the flow
diverter to the T-strut with a pop rivet. NOTE: if you OceanGuard requires a Filtration Cage this
step can be skipped and addressed as part of the Filtration Cage Installation.
Page 4 of 5
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalLog in to download the original file
Large file: the download may take up to a minute.
Searchable page text hides email addresses. Original files are unchanged and may show email addresses.