Approved Plan - Landscape Specification prepared by URBIS - OPW24/0110

         HANDI-MATE ™ HM6 HINGED DOOR SHED INSTALLATION GUIDE


1. Place the L/H Barge Cap over the Roof Sheet at the front of the shed. The front face of the Barge Cap should fit up against
the Roof Sheets (Figure 7.6).
2. The ends of the Barge Cap Should align with the end of the Roof Sheet. Fasten two coloured 10x25 Hex-Head Screws with
Neo Washers through the front face of the Barge Cap and into the Wall Channel Assembly. Fasten two coloured 10x25 Hex-
Head Screws with Neo Washers through the top of the Barge Cap and into the crests of the Roof Sheets (Figure 7.6).
Install the R/H Barge Cap in the same manner on the front right side of the shed. Install the remaining L/H and R/H Barge Caps
to the rear of the shed in the same manner (Figure 7.6).


                                                    L/H Barge Cap


                                                                                   Roof Sheet



                                                                                                      R/H Barge Cap
                       R/H Barge Cap




                                                                                                     L/H Barge Cap




  1.                                                                2.

                                                                                                                           mm
             Coloured 10x25 Hex-Head                                                                                 220
             Screw with Neo Washer




FIGURE 7.6