Approved Plan - Landscape Specification prepared by URBIS - OPW24/0110

         HANDI-MATE ™ HM6 HINGED DOOR SHED INSTALLATION GUIDE


1. Fit two Wall Channel Assemblies over the lapped Wall Sheets and Door Jambs. The end of the Wall Channels should fit up
against the end of the Corner Wall Sheet (Figure 4.2).
2. Fasten one 10x16 Hex-Head Screw through the third pilot hole of the bottom and top Wall Channels and into the Corner
Wall Sheet crest. Fasten six 10x16 Hex-Head Screws through the bottom and top Wall Channels and into every third Wall Sheet
crest (Figure 4.2).
3. Ensure the edge of the Wall Channels and Door Jamb are in-line. Fasten one 10x16 Hex-Head Screw through the third pilot
hole of the bottom and top Wall Channels and into the Door Jamb (Figure 4.2).




                            Split Wall Sheet                               10x16 Hex-Head Screw

              Corner Wall Sheet                                                        Wall Channel Assembly




                  Wall Channel Assembly
                                                                                                          Door Jamb




 1.                                            2.                                      3.




                                                                                            Edge of Wall Channel
                                                                                            and Door Jamb in-line


FIGURE 4.2