Approved Plan - Landscape Specification prepared by URBIS - OPW24/0110

         HANDI-MATE ™ HM6 HINGED DOOR SHED INSTALLATION GUIDE


Fit the Ridge Beam onto the top Wall Channel Assemblies. Ensure 1355mm spacing between the edge of the shed and edge
of the Ridge Beam (Figure 7.3).
1. Align the end of the Ridge Beam with the outer edge of the Wall Channel Assembly. Fasten two 10x16 Hex-Head Screws
through the pilot holes in the Ridge Beam and into the Wall Channel Assembly (Figure 7.3).
2. Fasten two 10x16 Hex-Head Screws through the pilot holes in the Ridge Beam and into the rear Wall Channel Assembly
(Figure 7.3).




                                       Wall Channel Assembly                                     Ridge Beam

                      10x16 Hex-Head Screw




                                m
                             5m
                          135




  1.                                                                2.


                        Ridge Beam
                                             10x16 Hex-Head Screw




                                                     Wall Channel
                                                     Assembly




                                            5 mm
                                         83

FIGURE 7.3


Refer to Figure 7.2 for Sheet layout. Lay a Roof Sheet onto the Ridge Beam and Wall Channel, ensuring the overlap end of the
Roof Sheet is facing the front of the shed (Figure 7.4).
1. Ensure the end of the Roof Sheet is in-line with the end of the Ridge Beam. Fasten five 10x16 Hex-Head Screws with Neo
Washers through the pans of the Roof Sheet and into the Ridge Beam (Figure 7.4).
2. Fasten five 10x16 Hex-Head Screws with Neo Washers through the pans of the Roof Sheet and into the Wall Channel
(Figure 7.4).
Install the opposing side Roof Sheet in the same manner.