Council archive · source document
MCU Application Report · 51997.2283.02
PO Box 432 POMONA QLD 4568 Ph 07 3063 9391 [email protected] ABN: 49 162 782 014
Performance Outcomes Acceptable Outcomes
4. visually integrated into the line and plane of
the building and roof design and does not
project beyond the height or width of the
building when viewed from the street and
adjoining properties.
Editor’s Note— Mechanical plant includes
generators, motors, compressors and pumps such as
air-conditioning or pool equipment.
AO21.4
Waste storage areas, clothes drying areas and
external storage areas are screened from the street.
AO21.5
Letterboxes and detached carports complement the
architecture and landscaping of the site.
Environment, heritage and scenic amenity Table 6.3.2.3 - Criteria for
assessment (part)
Performance Outcomes Acceptable Outcomes
Environment, heritage and scenic amenity Response
PO22 AO22.1 NA
Development: For landscape amenity reasons, cut or fill
is less than 1.5 metres in depth relative to
1. has minimal impact on the natural the ground level.
landform of the site;
2. does not lead to erosion or the AO22.2
transport of sediments off site; and Development does not result in sediment
or other material including building
3. does not lead to the disturbance of
materials or waste products being
natural features, buildings or structures
deposited or released into the road
of cultural heritage significance. reserve, stormwater drain or adjacent
properties.
AO22.3
Development on a site adjoining a local
heritage place respects the cultural
heritage significance of the place by
mitigating any adverse impacts on the
setting or integrity of the heritage values.
Editor’s Note— Local heritage places are
identified on the Heritage and Character
Areas Overlay maps in Schedule 2.
PO23 AO23.1 NA
Development on sloping sites: Building and structures are not constructed on
land with a slope greater than 25%.
1. is visually responsive to the natural
topography and sits within the AO23.2
landscape rather than dominating it; On sloping sites, split level buildings with small
and floorplates, that step down the slope are used
2. steps down slopes or uses as an alternative to standard single or double
suspended floor construction, storey construction to minimise building bulk
minimising cut or fill and avoiding and benching of the sites.
benching of the site.
Editor's note- refer to Figure 6.9.1A and Figure
6.9.1B
AO23.3
The distance between the ground level and
the lowest part of the floor of the building
does not exceed 3 metres.
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
MCU Application Report.pdfRelated documentApplication case desk ↗
About this file
- File size
- 1.2 MB (small file)
- File type
No other editions are linked here.