06/1168 - Change a Development Approval [As Published] · 132006.1168.02

NOOSA COUNCIL IDAS Development Application Decision Notice 7o0f 15

40. | Any damage caused to any public utility during the course of construction shall be repaired to Council's
standards and at no cost to Council.

41. Any alteration of any public utility or other facilities necessitated by the development of the land or
associated construction works external to the site shall be at no cost to Council.

42. The transportation of all materials to and from the site shall be undertaken in a manner such that no
particle matter escapes onto a public road. All vehicles carrying materials either to or from the site shall
be covered to prevent materials including dust being windblown from the vehicle.

43. As Constructed drawings and data shall be certified by a qualified experienced Civil Engineer for design
intent, and a Licensed Surveyor shall certify the cadastre and the location, level and type of all services
and structures. All of which shall be submitted to Council for checking and for Council's records.

The data must fully detail levels for all engineering works including but not limited to drainage structures,
finished ground levels and pavement surface levels. The data shall be submitted in the Asset Design and
As Constructed (ADAC) digital format. (Guidelines on the use of ADAC are available at
www.adac.com.au).

Approval of works shall not be granted unti! all As Constructed information has been supplied and
accepted by Council.

Environmental Health

44. The developer must provide waste storage and disposal facilities in accordance with Planning Scheme
Policy No. 9 “Waste Management Multi-Dwellings and Commercial and Industrial Premises", including an
external imperviously paved area correctly sized for all refuse and recycling containers and suitably
screened from public places and neighbouring properties. A bin wash area is required with a cold-water
tap, hose and drain outlet connected to sewer. The drain outlet is to be designed to prevent storm water
entry to the sewerage system and this can be achieved with a nib wall 50mm high and up to 700mm x
700mm wide (max 0.5m’), or alternatively the waste area can be roofed, or any other design approved by
Council.

45. All bin wash areas in excess of 700mm Square are to be roofed and the floor is to fall to a bucket trap with
the waste pre-treated by a grease arrestor prior to discharge to the sewer. The appropriate backflow
prevention devices are to be installed at the bin wash area. Bunding set above 75mm is required to
exclude excessive rain-water entering these areas.

46. A Trade Waste Application must be submitted prior to the issue of a Development Permit for Building
Works.

47. Full truck access is to be provided to each grease arrestor and/or pre-treatment device for cleaning and
servicing. Where access is restricted, a pump out line is required.

48. A completed Trade Waste application together with an applicable fee and two (2) sets of professionally
drawn plans showing the Trade Waste requirements in accordance with the Noosa Trade Waste Policy
are to be submitted to Council.

49. The property owner will be responsible for any cost incurred by an approved Cleaning Contractor relating
to the cleaning, servicing and contents removal from the grease arrestor, where access to the arrestor is
impaired or delayed.

50. The Trade Waste application fee of ($105.00) is required at the time of the application.

51. Trade Waste requirements are required to be in place, inspected and approved prior to the
commencement of trading or operation. The appropriate Trade Waste Permits will be issued following
approval at final inspection.

52. A place of food preparation and/or cooking is to have the liquid waste connected to a Trade Waste line,
that discharges to an approved grease arrestor of a size determined by Council's Trade Waste Policy.

53. All liquid waste produced by the commercial section of the development is “Trade Waste” and is to be
treated as required under the Noosa Trade Waste Policy prior to release to the sewer.

Environmental Services

 

54. An Environmental Management Plan (EMP) shall be prepared and implemented to ensure that the impact
of the development, during construction and operation, on the environment is minimised and that the
environmental values of the site and surrounding lands are protected and enhanced.

RT p:it. projects\208 girraween sports complex\12.0 documentation\documents from chris 090925\1 - approved meu plans\mcu
decision notice\sports fields mcu decision notice.doc