Skip to the record
Accept no substitutions.

Council archive · source document

IC0213NAM0001_SC14279_130304_IR_DL_dvb_signed · MCU12/0208

Attached to the e-mail DNRM Information Request - MCU12/0208.

of 7

Text shows just the words. Original shows the document exactly as it was published.

                                                                                                                      Notice
                                                                                                 Information request

           How the applicant proposes to mitigate the impacts on SCL or potential SCL where they cannot be
            avoided. Mitigation has the meaning defined in s138 of the Strategic Cropping Land Act 2011 and for
            permanently impacted land, means that either of the following, or a combination of the following has taken
            place for the land’s mitigation value2 –
              - A payment to the mitigation fund.
              - The entering into of a mitigation deed.


2. Vegetation Management Act 1999
   Introduction
   The proposed development is for a material change of use (MCU) and requires referral to the Department of
   DNRM as per, Material change of use - Clearing vegetation (Sustainable Planning Regulation 2009 - Schedule
   7, table 3, item 10).
   The DNRM assesses Material Change of Use applications using the Concurrence Agency Policy for Material
   Change of Use (MCU) 21 October 2009 (MCU Policy). A copy of relevant vegetation Policies and Codes can be
   accessed at www.dnrm.qld.gov.au .

   For developments that result in the clearing of remnant vegetation, applications are also assessed against the
   Regional Vegetation Management Code for South East Queensland Bioregion – version 2.1, 30 November
   2012 (RVM Code). Please note that DNRM is directed to consider clearing as a result of the MCU. This
   application requires assessment against the above mentioned MCU Policy and RVM Code.

   A copy of the current Regional Ecosystem Map – v6.1 can be downloaded at www.derm.qld.gov.au/remap .

   Results of preliminary assessment
   The referral of your application was not accompanied by sufficient information demonstrating compliance with
   the MCU Policy and RVM Code.
   It is apparent from the submitted Property Vegetation Management Plan (PVMP) and information that the intent
   of the project is to avoid clearing remnant vegetation by ensuring infrastructure is adequately setback from
   vegetation. The exception is the clearing proposed for access to the site from Hollett Road.
   A preliminary assessment has been conducted based on provided plans, specifically the Master Plan, Proposal
   Plan, Structure Plan and Koala Habitat and Vegetation Offset areas. There is an inconsistency in these plans in
   identifying the extent of development proposed which results in uncertainty about the amount of vegetation
   clearing required.

   Additional information required to assess the application
   Further information is required to be submitted to DNRM which includes:
           A plan and GIS shapefile of the setbacks proposed between mapped remnant vegetation and proposed
            infrastructure around all mapped remnant vegetation.
           Clarify the tracks to be created through mapped remnant vegetation – in particular any new roads
            proposed through the endangered remnant vegetation on lot 11. Picture below is from the provided
            ‘Illustrative Concept Master Plan’.




   2
       Mitigation Value is defined in s139 of the Strategic Cropping Land Act 2011.


   Page 4 of 7 • 091217                                                               Department of Natural Resources and Mines

Used in these records

About this file

File size
457 KB (small file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

IC0213NAM0001_SC14279_130304_IR_DL_dvb_signed.pdf · 457 KB (small file)

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.