Original source · versioned page text
Amended Delegated Report - Code - Planning - MCU25 0101 (As Published)
SD 2.01 C Proposed Elevations North and South prepared by 08/04/2026
Nielsen Jenkins
SD 3.00 C Proposed Sections AA and BB prepared by Nielsen 08/04/2026
Jenkins
SD 3.01 C Proposed Sections CC and DD prepared by 08/04/2026
Nielsen Jenkins
SD 3.02 C Proposed Sections EE and FF prepared by Nielsen 08/04/2026
Jenkins
SD 3.03 C Proposed Sections GG prepared by Nielsen 08/04/2026
Jenkins
Nature and Extent of Approved Use
4. The development must contain no more than one dwelling house, as defined by the Noosa
Plan 2020. No secondary dwelling, dual occupancy, multiple dwelling or other form of
residential accommodation is permitted on the subject land, except where such development
constitutes accepted development under the Noosa Plan 2020 or is otherwise approved by
a further development approval.
Building Height
5. The maximum height of the development must not exceed 8 metres above the ground level.
Including where excavation is undertaken the exposed portion of the external façade of the
building.
6. The ground level must be reinstated around the basement level to ensure no part of which is
more than 1 metre above ground level, apart from the driveway entrance.
7. Certification must be submitted to Council from a Registered Cadastral Surveyor (Qld) which
certifies that the building does not exceed the maximum height requirement of this Decision
Notice.
Car Parking
8. A minimum of 2 car parking spaces must be provided on site and always made available and
accessible for residents. Vehicle manoeuvring areas are provided on site in accordance with
the Australian Standards for Off-street car parking so vehicles enter and leave the site in a
forward gear.
Lighting Amenity
9. No flood lighting must be used on site. Any vertical illumination resulting from direct, reflected
or other incidental external lighting emanating from the site must not exceed 8 lux when
measured at any point 1.5 metres outside the boundary and at any level from ground level
upward.
External Colours & Finishes
10. External colours and finishes must be of muted environmental tones that blend with the
surrounding vegetation and landscape, with broad expanses of a single colour or reflective
surfaces not permitted.
Page 13 of 20
Document Set ID: 24807636
Version: 2, Version Date: 20/05/2026
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalLog in to download the original file
The download may take up to a minute.