Skip to the record
Accept no substitutions.

Council archive · source document

RFI - Traffic Response Letter · MCU24/0153

of 17

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Very large file (14.4 MB): the original may take a few minutes to open or download. The page text below is quick to read.

        fails to justify the reduced aisle width as the B85 vehicle is required to manoeuvre within the car stacker.
        Refer to the below extracts.
     2. The proposed basement carpark does not include the necessary maintenance shafts required to service the
        proposed car stackers as described in Page 37 of ITE Consulting’s Traffic Impact Statement (Report No.
        001, Rev. 01) dated 25 November 2024.
     3. No detail has been provided demonstrating the internal drainage ‘pit floor’ or external ‘pit edge’ (where
        required) as described in Page 41 of ITE Consulting’s Traffic Impact Statement (Report No. 001, Rev. 01)
        dated 25 November 2024.



Information Required
13. Provide amended plans that demonstrate proposed Carparks 1 – 6 (car stackers) are compliant with the
manufacturer's Product Sheet (contained in ITE Consulting’s Traffic Impact Statement (Report No. 001, Rev. 01)
dated 25 November 2024). The amended plans must be prepared by a suitably qualified person and include, but
not be limited to:
    a) minimum 6.5 metre aisle width where the aisle services a car stacker, unless otherwise justified (i.e.,
         demonstrate the B85 vehicle can enter the carpark square without manoeuvring with the carpark);
    b) demonstrate that the location and linemarking of the proposed car stacker is suitable for the entire
         system, including the necessary maintenance shafts and hydraulic mechanisms; and
    c) demonstrate the recommended drainage features of the car stacker are provided.

2.1. ITE Consulting Response

Driveway Crossover and Ramp

A ramp clearance assessment has been carried out based on an AS2890.1:2004 B99 vehicle which shows that
sufficient ground and head clearances will be achieved. An RPEQ certified clearance assessment is provided in
Appendix B.

Door Opening Clearance

The plans in Appendix B illustrate that clearance envelopes as per Figure 5.2 of AS2890.1:2004 will be achieved.
This allows for standard user Class 1 A bays of 2.4m width plus 300mm manoeuvring clearances to accommodate
turn paths as well as door opening requirements measured 1500mm from the centre of each bay.


Car Stackers

The car stackers do not include dividing walls between the bays. As such standard entry clearances as per Figure
5.2 of AS2890.1:2004 can be achieved, including the use of the 1100mm clearance adjacent to car bay 1&2 for the
top vehicle. The pit access is also manufactured to allow vehicle payloads when traversing over it. For the entry
and exit movements of the bottom vehicle, the movement of a standard B85 vehicle can enter and exit Car Bay
1&2 within the maximum allowable 3-point turn movement, given that when the bottom stacker has risen, safety
nets / walls demarcate the bottom stacker. The proposed aisle width of 5.9m is thus considered sufficient to
accommodate the minimum turn movements required fronting car bays 1&2, as indicated in Appendix B. Details
51 Elanda Street Traffic Response Letter            21 March 2025                                                  3

Used in these records

About this file

File size
14.4 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

RFI - Traffic Response Letter.pdf · 14.4 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.