Original source · versioned page text
2022-09-15 Ordinary Meeting Agenda
Text sections have not been matched to the original PDF pages. Use the original document to check page numbers.
ORDINARY MEETING AGENDA 15 SEPTEMBER 2022
2. Development undertaken in accordance with this approval must generally comply
with the approved plans of development. The approved plans are listed in the
following table unless otherwise amended by these conditions.
Plan No. Rev. Plan/Document Name Date
SK-01 G Floor Plans Prepared by Wiltshire Stevens 23.08.2022
Architecture
SK-02 G Elevations Prepared by Wiltshire Stevens 23.08.2022
Architecture
SK-04 G Sections Prepared by Wiltshire Stevens 23.08.2022
Architecture
Building Appearance
3. The parapet to the Emerald Street frontage is to be removed and replaced with a
hip roof design.
4. All deck and balcony areas above ground floor must not be enclosed by permanent
fixtures such as shutters, louvres, glass panelling or the like, except where required
to satisfy any privacy condition of this Decision Notice or if shown on the approved
plans.
5. Street awnings must be provided for the full frontage of the building to Emerald
Street. The awning must be designed to provide maximum continuous solar and
rain protection and promote all weather activity but provide opportunities for street
tree planting and landscaping. The width of the awning must be determined in
consultation with the Manager Development Assessment prior to the issue of the
operational works approval and is to include a sloping roof form. Posts are to be
provided and must be located to the outer most point of the awning so as not to
impede pedestrian traffic.
6. Ground floor shopfront glazing along the Emerald Street frontage must be fully
transparent to a minimum of 65% of the street frontage to allow passive
surveillance and encourage social interaction and must be provided at full height
(floor to ceiling).
7. Any security screens on the premises consist of grille or translucent screens and
not solid shutters, screens or roller-doors.
8. All mechanical equipment and other service infrastructure located on the site must
be:
a. located not less than 2 metres from a property boundary.
b. fully enclosed or screened such that they are not visible from the street
frontages nor adjoining properties. Where screened by landscaping,
landscaping beds must be at least 1.5 metres wide.
9. Roof materials must be non-reflective and designed with colours and styles to
minimise the visual impact of the development.
10. The street awning must extend for the full width of the frontage and be setback 1m
from the face of the kerb. Amended plans must be submitted prior to the issue of
an operational works approval.
11. All ground floor shopfront glazing must be protected against vandalism by the use
of a form of safety glass such as toughened or laminated glass.
12. During operating hours, all parking areas, pedestrian areas and entrances/exits to
all stairwells, lifts, foyers and public toilets must be well lit with vandal resistant
lighting and with intensities to satisfy the requirements of Australian Standard
AS1158 “Public Lighting Code”. Lighting must be designed to reduce the contrast
between shadows and well lit areas. In particular, appropriate security lighting must
Page 10 of 25
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalSearchable page text hides email addresses. Original files are unchanged and may show email addresses.