Decision Notice - Change to an Existing Approval - 010.2004.00004206.001 [As Published] · 132004.4206.02

                                                                                       2004/4206

50.   In this regard plans detailing the methods of controlling erosion and sediment are required to
      be submitted to the Council for approval prior to obtaining a Development Permit for
      Operational Works.
General
51.   A suitably qualified Registered Professional Engineer shall prepare engineering drawings and
      specifications for all engineering works, which shall be submitted in conjunction with an
      application for a Development Permit for Operational Works. In this regard a DXF/DWG file
      on GDA94 zone 56 grid of the proposed cadastre layout is to be submitted in conjunction with
      any application for Operational Works.
52.   Digital detailed design drawings and calculations shall be submitted with any application for a
      Development Permit for Operational Works in respect of roadworks and stormwater drainage
      works. To avoid conflict with underground pipes or services, all existing and proposed
      services required by the development shall be shown on the plans.
53.   To facilitate production of As Constructed drawings it is suggested that all design drawings are
      submitted in the Asset Design and As Constructed (ADAC) digital format. (Guidelines on the
      use of ADAC are available at www.adac.com.au).
54.   Any damage caused to any public utility during the course of construction shall be repaired to
      Council’s standards and at no cost to Council.
55.   Any alteration of any public utility or other facilities necessitated by the development of the
      land or associated construction works external to the site shall be at no cost to Council.
56.   The transportation of all materials to and from the site shall be undertaken in a manner such
      that no particle matter escapes onto a public road. All vehicles carrying materials either to or
      from the site shall be covered to prevent materials including dust being windblown from the
      vehicle.
57.   As Constructed drawings and data shall be certified by a qualified experienced Civil Engineer
      for design intent, and a Licensed Surveyor shall certify the cadastre and the location, level and
      type of all services and structures. All of which shall be submitted to Council for checking and
      for Council’s records.
      The data must fully detail levels for all engineering works including but not limited to drainage
      structures, finished ground levels and pavement surface levels. The data shall be submitted in
      the Asset Design and As Constructed (ADAC) digital format. (Guidelines on the use of ADAC
      are available at www.adac.com.au).
      Approval of the completed works shall not be granted until all As Constructed information has
      been supplied and accepted by Council.
River Flooding
58.   All buildings proposed on site (and areas utilised for carparking purposes associated with the
      buildings) shall be constructed to comply with Council’s Minimum Floor Height requirements
      as defined in Council’s Planning Scheme and on Council’s Scheme Maps at the time of issue
      of the Building Permit.
      In this regard and as an indication only - should have a Minimum Floor Height of RL 2.8m
      (AHD). These levels however are subject to change and verification shall be made to Council’s
      Land Development Section prior to obtaining a Development Permit for Building Works.
Carparking
59.   A minimum of 16 covered carparking spaces shall be provided on site generally in accordance
      with the approved plan numbered PD01-A, dated February 2004, and prepared by Middap
      Ditchfield Architects Pty Ltd, except as modified herein.
60.   A minimum of 16 covered carpark spaces shall be provided on site.
                                                                                     Page 7 of 14