Council archive · source document
RFI - Attachment 3 - Operational Waste Management Plan · MCU22/0094
Plans and drawings: the text below has words only, no drawings.
Original PDF page 10, section 1. The text section number identifies this passage in the reader.
Council may consider the following matters in assessing applications under the Planning Act 2017:
a) the types of waste generated;
b) waste generation rates;
c) minimum service levels;
Details provided
2. d) the types of waste storage bins;
throughout OWMP
e) location of waste storage areas and bin wash areas;
f) required size of waste storage areas
g) safe vehicle and pedestrian access to bins; and
h) nuisance issues.
Types of Waste Generated – Consideration of the following matters will determine the types of waste storage bins and the minimum
service level required;
Details provided
3. a) whether the waste will be putrescible or dry waste;
throughout OWMP
b) whether the waste will be recyclable waste; and
c) whether the waste will be heavy or light.
Melbourne City Council
4. Waste Generation Rates - Refer to SC6.10 - Appendix 1 which provides a guide to likely waste generation for various uses.
generation rates used.
Complies – Min. 2
Minimum Service Levels – Table SC6.10.5.1 indicates minimum service levels for uses. Council may seek to vary the requirements having
5. services per week
regard to the size, location and level of occupancy of the use.
proposed.
Specialised Waste Storage Bins – SC6.10 - Appendix 2 describes two types of specialised waste storage bins available through Council’s Council 240L and 360L
6.
contractor. MGBs proposed.
Size and location of Waste Storage Areas –
a) The following matters will be considered in determining an appropriate size for waste storage areas:
1. Types of waste and storage required:
• bins for putrescible waste;
• bins for recyclables;
• drums for waste cooking oils;
• bales for cardboard;
• bags or bins for green waste; and Complies –
• any other specialised waste storage bins needed, eg: medical waste; and
7.
2. Sufficient space between waste storage bins to allow for manoeuvring and washing of bins, where appropriate noting Details throughout
that the bin store must be large enough for the bins to sit next to each other, not behind each other. OWMP
b) Adequate lighting needs to be provided to allow the usage of the bin store after dark
c) Internal waste rooms should be well ventilated and have a smooth easily cleanable floor
d) Suitable drainage, with water discharging into a sewer drain, must be installed to allow the washing of bins and a tap with hose
connection available.
e) Waste storage areas can be roofed or unroofed.
1. Waste storage areas contain bunded and non-bunded areas depending on their size and the type of waste to be
stored. Where bunded areas are required:
Site: Lot 4, 28 Eenie Creek Road, Noosaville
Reference: 23BRW0003 7
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
RFI - Attachment 3 - Operational Waste Management Plan.pdfRelated documentApplication case desk ↗
About this file
- File size
- 6.3 MB (large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take up to a minute.