Skip to the record
For the highest quality transcripts.

Council archive · source document

Part 10 of 37 Appendix 8 - Queensland Coastal Plan Assessment MCU12/0208

of 48

Check the original when the exact wording matters.

Plans and drawings: the text below has words only, no drawings.

Very large file (26.4 MB): may take a few minutes to open.

Log in to see the plans as drawn
                                                                                                           Noosa on Weyba




3              Erosion Hazard Assessment

3.1           Design Wave Criteria
As mentioned in Section 2.4, there is no recorded wave data for this site. As a result, wave modelling was

required for this investigation in order to develop the required design wave parameters used in the foreshore
erosion modelling.

As study site sits on a lake foreshore, there is no swell wave action at the site and the wave dimate consists
almost exclusively of local wind driven waves. Thus design           wave     criteria were determined     by conducting
wind wave modelling using the 30 minutes in 100 years, and 30 minutes in 50 years wind speeds determined
in Section 2.3. The winds utili sed in the wave modelling were those from the ESE directional sector, as they
contained higher design wind speeds, while also generating wave whose propagation was likely to be shore-
normal. The wind wave modelling was conducted using the Sverdrup-Munk and Bretschneider (SMB)one
dimensional model of wind generated waves.

As the wave heights at the study site are affected by the water level of the lake, the wave climate analyses
took account of the fact that a rainfall event is likely to accompany high winds as part of a storm (such as an
east coast low). At the same time however, it is unlikely that the highest wind speeds would be associated
with the peaks of severe floods. Hence 5MB wave modelling was conducted by coupling the 100-years ARI
wind data with 20-years ARI flood levels, and 50-years ARI wind speeds with 10-year ARls flood levels, see
Section 2.2.    Design wave criteria at the site are shown in Table 3.1 below. Wave modelling also included
the projected sea level rises. This is common practice in coastal and estuarine modelling.


       Table 3-1     Study Area Design Wave Criteria
                         Current Scenario                2050 Scenario                     2100 Scenario
ARI (years)        .


                       Hs (m)          Tp (5)         Hs (m)          Tp (5)         Hs (m)         Tp (5)
       50                0.73            4.3            0.75            4.3           0.78           4.4

       100               0.76            4.4            0.78            4.4           0.82           4.5

The 50 and 100 years ARI wave heights do not vary significantly due to the shallow lake depth, limited wave
fetch and similar design wind speeds at the two ARI’s.




3.2           Shoreline Erosion Modelling

Storm erosion of the shoreline at the site was investigated using the SBEACH modelling system. SBEACH
was  developed by the U.S. Army Corps of Engineers (USACE)to investigate storm induced profile response
on fine to medium    grain sand beaches. It is an empirically based model that includes wave shoaling,
refraction, breaking, set-up and run-up. The model can simulate a temporally varying wave breaking-point,
which produces offshore bar migration. The model has been widely applied at sites all over the world and
has demonstrated reasonable levels of calibration.

SBEACH analyses were conducted at three profiles at the study site that were created by combining the lake

bathymetric data and foreshore topographic data described in Section 2.1. The locations of these profiles
are shown in   Figure 3.1. Profile locations were chosen that were even spaced but also represented varying
different topographic aspects of the shoreline, such as the gully area at the southern end of the study site.

The SBEACH modelling was conducted for a range of lake water levels and design wave conditions. This

modelling is outlined in Table 3.2 below. Cyclone caused waves have not been addressed. In those events
wind speeds could be higher, but the wave heights will become depth and fetch limited and wind direction
would change quite rapidly for cyclones in close vicinity.




28 September 2012                                         Cardno                                                        4
\\ausydcfs01 \COE.Jobs\CM\51 0119-Lake Weyba\009.ReportingDocsandFigures\R001 Ver 1.docx

Used in these records

About this file

File size
26.4 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Part 10 of 37 Appendix 8 - Queensland Coastal Plan Assessment MCU12_0208.pdf · 26.4 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.