Fencing Details URB-P0003847-000-SP-APPENDIX(2of2)-240719

(Optional) Drainage holes can be drilled to help trapped water flow out of the bottom Wall Channels. After assembling the
Walls, drill 6mm holes spaced approximately 350mm apart through the bottom Wall Channels of each Wall. Ensure holes are
located in-between Sheet crests. Ensure metal filings are removed from the channels as to prevent rust spots from forming.




     Drain Hole

                    350
                       mm



                                                              Wall Channel

FIGURE 1.2



WALL CHANNEL ASSEMBLY
Slide two Wall Channels into a Wall Channel Joiner. Ensure the six middle pre-punched holes of the Wall Channel Joiner and
Wall Channels line up. Fasten four 10x16 Hex-Head Screws through the four middle pilot holes of the Wall Channel Joiner and
into the Wall Channels (Figure 2.0).
Assemble three more Wall Channel Assemblies in the same manner so that there are four Wall Channel Assemblies.




                                   Wall Channel




                                                                             10x16 Hex-Head Screw




                                                                                       Wall Channel Joiner




                                            Wall Channels fit
                                            into Wall Channel Joiner


                                                                                           Wall Channel




FIGURE 2.0