Fencing Details URB-P0003847-000-SP-APPENDIX(2of2)-240719

         HANDI-MATE ™ HM6 HINGED DOOR SHED INSTALLATION GUIDE


REAR WALL ASSEMBLY
Stratco Handi-Mate Windows
Refer to the “Window Installation” section at the end of this
document if installing a Stratco Window, or visit a Stratco
store for more information.




                                          Wall Sheet
                                                                                                        Wall Channel Assembly

                   Corner Wall Sheet




                                                                                                           Wall Sheet

             Wall Channel Assembly                                                         Wall Sheet




FIGURE 3.0


Using Trestles or Blocks to support the sheets, lay the Corner Wall Sheet down first. Then lay down the three Wall Sheets. Pay
attention to the ‘overlap’ and ‘underlap’ lapping details (Figure 3.1).


                                       Sheet ‘Overlap’
                                   Sheet ‘Underlap’


                                                                                                             Wall Sheet
                                                                          Wall Sheet
                                                         Wall Sheet
               Corner Wall Sheet



FIGURE 3.1


1. Fit the Wall Channel Assembly over the lapped Wall Sheets. The end of the Wall Channel should fit up against the end of
the Corner Wall Sheet (Figure 3.2).
2. Wall Channels have three pilot holes in each end. Fasten through the third pilot hole of both Wall Channel ends and into the
Wall Sheet crests. Fasten through the Wall Channel Assemblies and into every third Wall Sheet crest using ten 10x16 Hex-Head
Screws in each Wall Channel Assembly (Figure 3.2).