Fencing Details URB-P0003847-000-SP-APPENDIX(2of2)-240719

A coloured Rivet should be installed at sheet laps in the Roof Sheets, Rear Wall, Wall Corners and Door Jambs. Drill a 3.5mm
hole through the centre of each sheet lap and install a coloured Rivet (Figure 7.7).




                          Coloured Rivet



FIGURE 7.7


Water-Proofing the Floor (Optional)
Water may enter the Shed between the bottom Wall Channels and Floor. Water ingress can be mitigated by applying silicone to
the gaps along the Floor. From the inside of the Shed, apply a bead of silicone along the entire perimeter of the Shed, including
along the Corner Brackets and Wall Channel ends. Do not apply silicone to the outside of the Shed as this will not allow water
to flow out and away from the Shed (Figure 7.8).




                                                      Silicone Bead

                                                              Wall Channel
FIGURE 7.8



SHED MAINTENANCE
It is vital that all metal swarf and filings are removed from the shed as to prevent rust spots from forming. Your Stratco Handi-
MateTM Shed will maintain its good looks for even longer with a simple wash and wipe down. Cleaning should be performed as
often as is required to remove any dirt, salt and pollutants.
Stratco Handi-MateTM Sheds are produced from the highest quality materials and will provide many years of service. Refer to
the ‘Selection Use and Maintenance’ brochure for more information on how to get the best out of your product.