Skip to the record
The gold standard in government transparency.

Council archive · source document

0015CE08.001

of 12

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Text sections not matched to the original PDF pages. See original document to check page numbers.

The classification has been calculated from test work performed on the soil profile encountered on the
            day of our fieldwork and consideration .of AS2870-1996. The ‘P’ Classification relates to the loose sands
            encountered in the upper profile of our test sites. Any disturbance of the soil profile, may result in a
            change to the classification. The attached design, has allowed for the influence of the earthworks
            described in section 5.0 below.

            3.0     SITE DESCRIPTION:
;           The construction area has a gradient in the order of 4%.
            Vegetation on the construction area (and nearby surrounds) consists of grasses and scattered trees.
            The existing surface drainage is fair and sub-surface drainage is good.

            4.0     FINDINGS:
            The soil profiles encountered are shown on the attached log sections.
            No water table was encountered during our testing program.
            The sandy soils encountered are susceptible to collapse when unconfined. This may effect excavations
            and result in additional earthworks and increased concrete volumes. For further information please refer
            to the attached critical line diagram.
            The samples classified on site were assessed as having low to negligible plasticity, therefore laboratory
            testing was considered unnecessary.
            We have assessed the expected differential movement of the soil profiles encountered to be the
            equivalent of a site with a Ys of less than 20mm.
            For buildings within the scope of AS 2870-1996, safe bearing is available at 300mm into the MEDIUM
            DENSE SAND. This strata is shown shaded on the attached logs

      ‘     5.0     SITE PREPARATION DETAILS:
            We recommend scraping this site free of all organic material and debris, then cutting the construction
            area to form a level pad. There must be no fill placed beneath the foot-print of the building. The
         ’  prepared construction pad must be entirely on cut natural ground. A small surface spoon drain with a
            suitable outflow should be excavated at the base of the cut. Any fill placed outside the foot-print should be
            clean material from the cut, laid out in 150mm (maximum) layers and tracked rolled with the excavator
            (six passes in each direction). Cut batters of 1 to 2 (vertical to horizontal) and fill batters of 1 to 3 will be
            stable providing ail fill is compacted as above and exposed banks are protected against erosion.
            Where a retaining wall is required, a cut batter of 1 to 2 (vertical to horizontal) in the sand profile taken
            from the base of the proposed walt should be excavated. These earthworks must incorporate shallow
            surface spoon drains at the base and along the high side of the cut. Drains must have an efficient outflow
            down-slope and clear of the construction area. The exposed face should also be protected against the
             potential for stormwater erosion. Should these recommendations be un-achievable the builder should       -
            seek guidance from this office on temporary shoring, benching or other suitable techniques.
            Areas where existing structures or trees are removed shail be backfilled with engineer approved fill
             materia! compacted in accordance with AS2870-1996, or alternative measures to be provided by the
             engineer.

Used in these records

About this file

File size
702 KB (small file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

0015CE08.001.pdf · 702 KB (small file)

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.