Skip to the record
Trusted by locals. Built for Noosa.

Council archive · source document

0015CE08.001

of 12

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Text sections not matched to the original PDF pages. See original document to check page numbers.

. ‘a     ff                                                          .

              Any loose or soft material uncovered in the site preparation shall be removed and replaced with approved
              fill material compacted in accordance with AS2870-1996, or alternative measures to be provided by the
              engineer.
              Site drainage during construction is important. Stormwater run-off should be diverted away from any
              foundation excavations and not be able to pond within 5.0m of the building footprint. Temporary spoon
              drains or other practical methods should be used.
              We recommend using a footing system as per the attached plans and details on the prepared
              construction pad.
              Where site drainage and landscaping does not conform to the specifications of AS 2870-1996 and CSIRO
              information Service Sheet BTF 18 (2003) significant damage to the building can be expected. A single
              copy of this document is issued with the original issue of this report. Please consult your builder or
              contact this office to obtain a copy.

              6.0    FOOTING AND SLAB SPECIFICATIONS:
              Footing Details:                                                                        .
             Alt footings must be founded a minimum of 300mm into MEDIUM DENSE SAND (shaded on the attached
              log sections). Dimensions and reinforcement requirements are detailed in the following footing plan and
              cross-sections.
              Where the founding tevel is deep or is covered by the introduction of fill the footings are to be increased in
              depth to reach the level. Alternatively the footings can be supported on backhoe dug or drilled piers
              founded at or below the founding level. Refer to this office for details.
              Drilled Piers Supporting the Footings:                               ,
              Where the MEDIUM DENSE SAND is deep or to be covered by fill the footings can be supported on
              350mm diameter drilted piers founded at a minimum of 300mm into the MEDIUM DENSE SAND.
             Aiternatively the footings can be founded on steel screw piers. The piers are to be designed and installed
              by a specialist contractor to achieve the loads nominated on the structural plans.
              Drilled Piers Supporting the Slab:
      .       Slab piers are required where there is more than 300mm of uncontrolled fill beneath the slab. They are to
              be founded at a minimum of 300mm into the MEDIUM DENSE SAND. Special attention must be paid to
              the extra thickening and reinforcement required over each pier as detailed in the attached plan and
             details.                                                               ;
              Where drilled piers supporting columns or posts are not poured with the slab they must be connected to
              the slab in the following manner:
              «  4x N12 bars must be anchored 500mm into the drilled pier and be bent 300mm horizontally into the
                 footing or slab as required.
              ¢  Where a column penetrates a beam or footing 3x N12 bars must be bent around the column to lap the
                 trench mesh by 500mm both sides.

              SCG CONSULTING ENGINEERS                           3                                   SCG Ref: 16078(S)

Used in these records

About this file

File size
702 KB (small file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

0015CE08.001.pdf · 702 KB (small file)

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.