Skip to the record
The only place to find full transcripts.

Original source · versioned page text

2014-05-26 General Committee Agenda

of 33

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

Text sections have not been matched to the original PDF pages. Use the original document to check page numbers.

GENERAL COMMITTEE MEETING AGENDA                                                      26 MAY 2014


8.    The batters of the existing fill must be regraded such that that are a maximum grade of:
      (a)       1 in 6 where in proximity to waterbodies
      (b)       1 in 4 for grassed areas.
      (c)       1 in 3 for planted areas
9.    No further filling, excluding the repairs to the existing surface, is to be undertaken on the
      site without Council approval.
10.   No further disturbance of the riparian vegetation, unless for ecological restoration works, is
      to be undertaken on the site without Council approval.
11.   All stockpiles of fill material must be located above the 1%AEP flood level.
12.   All exposed or disturbed surfaces must be suitably stabilised as soon as is practicable after
      works have been completed. *(Refer to Advisory Note)
13.   Where damage occurs to any council asset as a result of the development works, it must
      be repaired immediately where it creates a hazard that presents risk to person or property.
      Other damage must be repaired prior to completion of works.
14.   All works must be completed within 12 months from the date that this permit takes effect.
ADVISORY NOTES
The following notes are included for guidance and information purposes only and do not form
part of the assessment manager conditions:
General Advisory Notes
1.    In regard to the required “Flood Impact Assessment” Council will provide access to the
      current data relating to flood modeling within the Pomona township.
2.    Council reserves the right to call up any performance bond held or levy charges against the
      property, should emergency works be required to be undertaken by Council to make the
      site safe due to inactivity on the development site for extended periods of time.
3.   Should any changes or modifications to the approved plans be required as a result of
     construction constraints, a “Request to change an existing approval” under the Sustainable
     Planning Act 2009 must be made. Amended plans clearly indicating the changes must be
     lodged with this application along with the appropriate fees.
Prestart Meeting Request
4.   Contact Council on 5329 6244 to arrange a prestart or an inspection giving a minimum of 5
     business days notice of preferred inspection time.
Erosion and Sediment Control
5.    Accepted best practice standards include:
      (a)        the Sunshine Coast Regional Council Manual for Erosion and Sediment Control
                 V1.2 or other superseding document subsequently adopted by Council;
      (b)        Best Practice Erosion and Sediment Control, International Erosion Control
                 Association (2008)
6.    As a general rule, a site is determined to have achieved effective short-term stabilisation if
      at the completion of the works:
      I. Methods of stabilisation are:
                appropriate for slopes and slope lengths; and
             are consistent with best practice environmental management practices such as in
              the Manual for Erosion and Sediment Control or the IECA Manual; and
      II. Stormwater runoff from the site is not currently, and is not likely to result in visible
          evidence of sedimentation or erosion, or lead to water contamination.




                                                                                      Page 5 of 33
Log in to download the original file

2014-05-26 General Committee Agenda(PDF, 1MB).pdf · 1.5 MB (small file)

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.