H - Revised Integrated Water Management Plan by Cardno (inc MUSIC file) (13.09.19)

                                                            Ocean Protect | OceanGuard Installation Guide


   5. Align T-strut onto L-brackets and secure with pop rivets, repeat for second strut




Flow Diverter Install
   1. Measure the internal dimensions of the pit at the height at which the plastic is to sit. If necessary
      trim flow diverter panels to fit internal dimensions (add an additional 20mm each side to ensure
      tight pressure fit)




   2. With the plastic bent slightly upwards, lower the Top Section into the pit, guiding the unit so that it
      locates on the T Sections struts.




   3. Drill a 5mm hole through the flow diverter and into the strut for each T-strut, and secure the flow
      diverter to the T-strut with a pop rivet. NOTE: if you OceanGuard requires a Filtration Cage this
      step can be skipped and addressed as part of the Filtration Cage Installation.


                                                                                                  Page 4 of 5