Astp_Tp_Rpt

   Setbacks               Frontage – 10m                    Frontage – greater than 10m             Yes
                          Side (north) – 10m                Side (north) – 6.1m                     No
                          Rear (east) – 10m                 Rear (east) – greater than 10m          Yes
                          Side (south) – 10m                Side (south) – 6.2m                     No
                          Side (west) – 10m                 Side (west) – 8.1m                      No
   Cut & Fill             Maximum – 1.5m                    Max. Cut – 3.25m                        No
                                                            Max. Fill 1.84m                         No


Whilst the built form generally steps down with the slope of the site, as the site contains an average
slope of approximately 27%, some cut/fill will be required in order to construct the proposed new
Dwelling House. The majority of cut earthworks will occur at the rear of the Dwelling to create the ‘sub-
ground level’, resulting in changes to site levels greater than 1.5 metres in height relative to the ground
level (3.25m of cut and 1.84m of fill at the highest point of difference). The majority of earthworks will
be confined to the plan area of the Dwelling, ensuring that cut and fill works are retained by the
building’s blockwork walls (refer to Figures 4 and 5 below).




      Greatest point
      of difference




Figure 4 North Facing Section – Proposed Cut/Fill Earthworks (Source: Reitsma & Associates, 2023)




                                                                            Greatest point
                                                                            of difference




Figure 5 South Facing Section – Proposed Cut/Fill Earthworks (Source: Reitsma & Associates)