Skip to the record
For the highest quality transcripts.

Council archive · source document

REFERENCE DOCUMENTS - RAL25/0004 (As Published)

of 1095

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Very large file (40.5 MB): the whole original can take several minutes to open, especially on a phone. Text is quick to read.

Original PDF page 999, section 1. The text section number identifies this passage in the reader.

Form

Contaminated land investigation document

 

 

Section 389(2) of the EP Act
requires a site investigation report or
validation report to include the
content summarised in the adjacent
table. In the event that any of these
statutory requirements are not
applicable, the CLID must still
address the matter. For example,
include a statement in the CLID that
waste was not stored, or earthworks
were not carried out. Module 6
provides information on how to meet

these statutory requirements.

Subsections ss. 389(2)(iii)(A) to (E)

require a description of the following

in the surrounding area:

¢ all environmentally sensitive
areas

e the location of all water,
watercourses and wetlands

¢ the location of all stormwater
drainage

e all uses of the land, including
uses that may affect the safety
of the relevant land or cause
environmental harm

e all activities carried out that may
affect the safety of the relevant
land or cause environmental
harm

For waste disposed of or stored on

the land that contains, or may

potentially contain, hazardous

contaminants, subsections

ss. 389(2)(iii)(A) and (B) require:

e details of the location, volume
and type of waste

e details of any potential
contamination of the land
caused by disposing of or
storing the waste on the land.

 

 

For a site investigation report or validation report

Table B6
by s. 389(2) of the EP Act

Confirm the CLID provides the following content required

 

Summary of statutory requirements
for a site investigation report or
validation report

s. 389
subsect

Provided in
the CLID?

 

Reasons the land’s particulars are
recorded in a relevant land register.

Yes W

 

Description of all surface and
subsurface infrastructure on the land.

(2)(a)(ii)

Yes Vo

 

Description of the surrounding area,
including each of the matters required
by subsections ss. 389(2)(iii)(A) to (E).

(2)(aytiti)
(A) to (E)

YesW

 

Details of waste disposed of or stored
on the land, including each of the
matters required by subsections

ss. 389(2)(iv)(A) and (B).

(2)(a)(iv)
(A) & (B)

Yes W

 

Description of the geology and
hydrogeology of the land.

Yes W

 

Details of any environmentally relevant
activities or notifiable activities carried
out on the land, including materials
used and waste produced during the
activities.

Yes

 

Details of any earthworks carried out
on the land, including the materials
used and waste produced during the
earthworks.

(2)(a)(vii)

Yes W

 

Contamination levels before and after
any remediation work on the land.

Yes VW

 

A statement of whether the land is
prescribed contaminated land.

Yes

 

If the land is contaminated, a
statement of the extent to which the
land is contaminated.

 

 

 

Yes ¥
N/A

 

 

 

 

 

Page 9 of 24 * ESR/2023/6339 + Version 1.03 + Last reviewed: 19 MAY 2023

Document Set ID: 23717062
Version: 0, Version Date: 01/01/1900

Department of Environment and Science

Used in these records

About this file

File size
40.5 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

REFERENCE DOCUMENTS - RAL25_0004 (As Published).pdf · 40.5 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.