Minor Change Report MCU24 0143 01 (As Published)

               In particular the applicant seeks to change the design of the approved cabins to two (2) permanent
               modular buildings in the same location as the approved cabins.
               This is due to building certifier advice that the approved cabins would not be able to meet the
               energy efficiency, bushfire and waste management requirements under the National Construction
               Code.
               It is proposed that this development be staged with the northern cabin (Cabin 1) presenting stage
               1 and the southern cabin (Cabin 2) presenting stage 2
               Both Cabins contain the same floor plan, containing a single bedroom, as well as a combined
               kitchen, living and dining area. The cabins will have a Gross Floor Area of 46.48m2 and each have
               a deck area of 30m2.
               The proposed cabins are modular (high-set) structures and contain a height of approximately 4
               metres above ground level. The façade of the structures will comprise of horizontal weatherboard
               cladding, pitched skillion roof forms and will be finished with muted earthy tones.


               The locality and proposal plan are included below.




                                                       Figure 1 – Locality




                                                                                                   Page 2 of 11

Document Set ID: 25028822
Version: 7, Version Date: 02/09/2026