Skip to the record
The first. The best. The only NoosaWatch™.

Council archive · source document

Development Application Part 2 of 2 - Application Plans, Bushfire Management Plan and Fire and Evac Plan - OPW13/0463

of 92

Check the original when the exact wording matters.

Plans and drawings: the text below has words only, no drawings.

Very large file (76.1 MB): may take a few minutes to open.

Log in to see the plans as drawn
7.2       Asset Protection Zones and Landscaping



    Components of an Asset Protection Zone                                                                      hazard




                             Inner protection area




            ~                I




Figure 14. Components of an Asset Protection Zone (APZ)

Asset protection zones are the most strategically valuable defence against radiant heat and flame, and to a
lesser extent embers.


The landscaping plan shall include the establishment and maintenance of an "Inner Protection Area" (IPA)of
a minimum     of 10m out from any buildings, and maintained free of available fuel. Some landscaping plants

may be used in this area so long as they are selected for their low combustibility, by virtue of high moisture
content, low volatile oil content, high leaf mineral levels, large fleshy leaves, absence of shedding bark. They
should be placed so as to not provide either vertical or horizontal connectedness of plant material, or
contact with flammable parts of buildings.



An Outer Protection Area involves removal of the understorey so as to deprive an advancing firefront of its

fuel continuity, and thereby collapsing the fire front. In this case, we are recommending that the entire

subject lot is managed as an IPA.

The retention of plants identified in Drawings Number 12-186 LP-01 and LP-02 of the Vegetation
Management Plan (required by Council under Decision Notice MCU 12/0133) potentially risk creation of fuel
pockets close to flammable structures and parts of buildings. In order to mitigate this risk, it is
recommended that:


     1.   Non combustible mulches are used in landscaping.
    2.    Where native vegetative species are used, they should be selected from Appendix 1 (Native plants
          of lesser combustibility) and be of species/ age that will rapidly reach around 3m in height, which
          can be   hedge trimmed, with dense foliage. Acmena spp and Syzigium spp provide a range of good
          options. They serve to separate retained natives, and dampen or subdue potential fire behaviour.
    3.    Leaf litter should not be allowed to accumulate at ground level, and should be raked up from
          gardens/under boardwalks and buildings and should be removed from site, particularly during the
          fire season (August to February).


Radiant heat barriers (either man such as non combustible/colorbond                   or of low   combustibility/fire
retardant vegetation) should be incorporated into APZ design as shown in Figure 15, to further reduce

exposure of buildings to radiant heat. Vegetative barriers can potentially become involved in fire if they are
permitted to dry out, and a key requirement (if the vegetative option is used) is to ensure that vegetation is
well watered and not suffering moisture stress, particularly throughout the fire season. The non
combustible option is recommended.




Report compiled by Bushfire Risk Reducers for Fulton Trotter Architects, April 2013                        Page 21

Used in these records

About this file

File size
76.1 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Development Application Part 2 of 2 - Application Plans, Bushfire Management Plan and Fire and Evac Plan - OPW13_0463.pdf · 76.1 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.