Minor Change Existing Approval MCU23/0094 01 [AS PUBLISHED] · MCU23/0094.01

                               DEVELOPMENT PERMIT FOR RECONFIGURING A LOT (RAL23/0014)
                      When Conditions Must Be Complied With
               1.     Unless otherwise stated, all works required by the conditions of this Decision Notice must be
                      completed prior to submission of the subdivision plan to Council for compliance assessment
                      Currency Period
               2.     This development approval lapses if the requirements of the conditions have not been
                      completed and an application for plan seal is not lodged with Council by 13 May 2030 unless
                      an application to extend the currency period is approved by Council.
                      Approved Plans
               3.     Development authorised by this approval must be undertaken generally in accordance with
                      the Approved Plans listed in the table/s below. The plans must be amended to incorporate
                      the amendments listed within the table below and resubmitted to Council prior to the issue
                      of any Development Permit for Building Works*

                           Plan No.             Rev.   Plan/Document Name                               Date

                           -                    -      -                                                -

                      The following plans require amendment.

                           Plan No.             Rev.   Plan/Document Name                               Date

                           WD.1.21              A      Reconfiguration   Plan    prepared            by 10.04.2024
                                                       Blackwood Architects & Design

                           Amendments           Provide additional details on the plan, including:
                                                •   Proposed Lot numbers;
                                                •   Common property areas;
                                                •   Any required easements; and
                                                •   Dimensions of Lots.
                      *(Refer to Advisory Note)
               4.     All lot numbering on the subdivision plan to be submitted to Council for compliance
                      assessment must remain as shown on the Approved Plans.
                      Boundary Encroachments
               5.     Certification must be submitted to Council from a Registered Cadastral Surveyor (Qld) which
                      certifies that:
                      a.       all constructed access and roadworks (including associated fill batters and retaining
                               walls) are fully contained within a dedicated reserve or registered easement.
                      b.       all utility services and connections (eg. electricity, telecommunications, water,
                               sewerage) are wholly located within the lot they serve or alternatively included within
                               an easement.
                      c.       all dams (including ponded water, dam walls and associated spillway structures) are
                               wholly located within the boundaries of a single lot.
                      d.       all retaining walls and structures are fully contained within the lot they retain unless
                               otherwise required by condition.
                      e.       any fill, including fill batters, are wholly contained within the subject site and not on
                               adjacent properties.




                                                                                                            Page 11 of 30
Document Set ID: 23245480
Version: 4, Version Date: 17/09/2024