13. OBoat Hire - Prescribed Tidal Works Code

NOOSA RIVER ENTERPRISES PTY LTD AS TRUSTEE UNDER INSTRUMENT 708121382 – PRESCRIBED
TIDAL WORKS – OBOATS REDEVELOPMENT
Performance Criteria                   Acceptable Solution                        Comments

Design, construction and safety – boat ramps and slip ways for private purpose

safe movement of vehicles or persons   a)   subject to paragraph (d), the         The proposal is not a boat ramp or
over the boat ramp or slip way.             upper surface of a boat ramp or       slip way.
                                            slip way has a width of:-
                                            (i) for a boat ramp or slipway
                                                 with vehicle access – no less
                                                 than 3.6m; or
                                            (ii) for a boat ramp or slipway
                                                 without vehicle access – no
                                                 less than 3.0m;
                                       b)   subject to paragraph (d), the
                                            whole upper surface of a boat
                                            ramp or slip way is treated to
                                            prevent it from becoming
                                            slippery by using any of the
                                            following methods:-
                                            i)   forming grooves over the
                                                 surface, as close as possible
                                                 to 40mm wide, 20mm deep
                                                 and 150mm apart, and at an
                                                 angle as close as possible to
                                                 70 degrees to the centre-
                                                 line of the boat ramp or slip
                                                 way;
                                            ii) covering the surface with a
                                                 substance ordinarily used
                                                 on to prevent skidding;
                                            iii) making, through a physical
                                                 act, the surface coarse
                                                 before it sets, including, for
                                                 example, by raking the
                                                 surface;
                                       c)   subject to paragraph (d), the
                                            upper surface of a boat ramp /
                                            slip way for which a winch is not
                                            used to hoist or haul vessels onto
                                            the boat ramp / slip way has a
                                            gradient not steeper than:-
                                            i) if the surface is treated by
                                                 using a method mentioned
                                                 in paragraph (b)(i) or (ii) –
                                                 1:7; or
                                            ii) otherside – 1:10;
                                       d)   if a relevant planning scheme
                                            standard is more stringent than
                                            the standard in paragraph (a), (b)
                                            or (c) – the relevant planning
                                            scheme standard, to the extent it
                                            is more stringent than the
                                            standard in paragraph (a), (b) or
                                            (c).