Skip to the record
Trusted by locals. Built for Noosa.

Original source · versioned page text

response to information request Plover St

of 5

Page text shows just the words. Original shows the document exactly as it was published.

   3. Provide details of landscaping for the proposed dwelling house, noting the
      landscaping requirements within the Coastal Protection and Scenic Amenity
      Overlay Code and Low Density Housing Code.

The proposal meets the minimum 20% landscaping requirement for the site (provided
>25%), including areas for deep landscaping around all setback boundaries.




   4. Provide amended plans that comply with setback requirements as outlined
      in the Medium Density Residential Zone Code.

Setback lines are included on the amended proposal plans, demonstrating compliance
with the minimum setback requirements (relative to each point of the ground levels).

   5. Provide amended elevations that provide detail of the proposed pool that
      comply with setback requirements.

A copy of the detailed contour survey by dts consultants is attached.

   6. Provide a site-specific geotechnical report prepared by a suitably qualified
      person and include recommendations for the construction of the proposed
      development and the protection of adjoining properties.

A copy of the geotechnical report by Lindsays Consulting Engineers is attached
recommending construction techniques.




                                                                        Page 3 of 5
Log in to download the original file

response to information request Plover St.pdf · 1.4 MB (small file)

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.