Minor Change Existing Approval - MCU19 0049 01 (As Published) · MCU19/0049.01

                      Outdoor Lighting Devices
               57.    Lighting associated with the use must be designed, sited, installed and tested to comply with
                      Table 2.1 & 2.2 of Australian Standard AS4282-1997 “Control of the obtrusive effects of
                      outdoor lighting” using a control level of 1.
               58.    Certification must be submitted to Council from a qualified person which certifies that all
                      outdoor lighting devices comply with the requirements of this Decision Notice at the time of
                      commissioning.
               59.    For the purpose of certifying outdoor lighting devices for the development, a qualified person
                      is:
                      a.      a Registered Professional Engineer of Queensland;
                      b.      an environmental or electrical design consultant with a minimum of 3 years current
                              experience in the field of outdoor lighting.
               DEMOLITION
                      Approved Plans
               60.    Demolition must be undertaken in accordance with this approval and comply with the
                      approved plans of development.
                      Performance Bond
               61.    Security in the form of a cash bond or trading bank guarantee to the sum of $5,000 must be
                      submitted to Council prior to the commencement of demolition works. The cash bond or
                      trading bank guarantee will be returned on performance of the demolition conditions of this
                      approval less any costs incurred by Council in respect of enforcing performance of these
                      demolition conditions. Council reserves the right to call upon the bond or guaranteed sum to
                      effect compliance with conditions.
                      Works
               62.    Demolition must be undertaken in a manner that causes no detrimental effect upon the
                      amenity of the neighbourhood by reason of the creation of excessive noise, lighting, air-borne
                      hazards, atmospheric pollutants (including dust or odours) nuisance or any other emissions
                      in accordance with the nuisance provisions of the Environmental Protection Act 1994.
                      Waste management
               63.    A Waste Management Plan (demolition) must be submitted in accordance with Planning
                      Scheme Policy 11 - Waste Management Plan and approved by Council’s Waste Coordinator
                      prior to the commencement of demolition works.
                      The purpose of the Waste Management Plan is to facilitate the segregation of waste for the
                      effective reuse and recycling of such materials. Segregated wastes attract significantly
                      reduced disposal fees at the landfill with some items free. Higher gate fees are charged for
                      mixed waste.
                      Waste storage areas must provide for adequate separation of all reusable, recyclable and
                      waste materials. These must be located so that they are convenient and safe to use.
                      The Plan must contain the following information:
                       a. Traffic Management Plan prepared by suitably qualified person for the demolition works
                          period. All required traffic control signage must be in accordance with the Manual of
                          Uniform Traffic Control Devices (MUTCD);
                       b. All required erosion and sediment control measures to be employed or undertaken
                          during the demolition works to ensure sediment and other material from the demolition
                          does not leave the site;
                       c. The erosion and sediment control measures must be designed, installed and maintained
                          in accordance with current best practice standards until all disturbed surfaces are
                          stabilised;


                                                                                                      Page 9 of 16
Document Set ID: 24873125
Version: 4, Version Date: 18/06/2026