Decision Notice - 010.2007.00001446.001 [As Published] · 132007.1446

NOOSA COUNCIL IDAS Development Application Decision Notice                                                 4 of 12


9.     The proposed development shall have all kitchen, laundry and bathroom fittings that comply with the AAA
       Water Conservation Rating System as defined by the AS/NZS 6400 (Water Efficient Products - Rating
       and Labelling 2003) and AS/NZS 3500 (National Plumbing and Drainage Standard Part 1.2), with toilets to
       comply with the AAAA Water Conservation Rating System. All tap ware and shower roses shall not
       exceed a maximum flow of 9 litres per min. Dishwashers and washing machines are excluded from this
       requirement.

10.    The Development Permit for a material change of use of premises lapses if the use has not happened by
       17 January 2012, unless an application to extend the currency is approved by Council.
Building Services
11.    Prior to the commencement of development, a Development Permit for building works must be obtained.

12.    The works must be undertaken in a manner that causes no detrimental effect upon the amenity of the
       neighbourhood by reason of the creation of excessive noise, lighting, air-borne hazards, atmospheric
       pollutants (including dust or odours) nuisance or any other emissions in accordance with the nuisance
       provisions of the Environmental Protection Regulation 1998 or Council’s Local Law No. 12 – Control of
       Nuisances.
Land Development
Lot Amalgamation
13.    All lots and parts of lots that form part of this application shall be amalgamated into one undivided
       allotment in accordance with Section 3.7.3 of the Integrated Planning Act and the Plan of Survey
       submitted for registration at the Land Titles Office. Proof of title being issued for the amalgamated lot
       shall be submitted to Council prior to the issue of the Development Permit for Operational Works.
Vehicle Access
14.    A vehicular access driveway to serve proposed unit 1 of the development shall be constructed from the
       Grant Street frontage of the site with a maximum width of 4.5m. Vehicle access to the proposed unit 2 of
       the development shall be from the existing access driveway at the rear of the site.

15.    The driveway shall be designed and constructed to Council’s design standards and to grades that prevent
       vehicles from scraping and/or bottoming whilst also allowing pedestrians movements along the footpath
       without any step or level difference. Should any driveways be constructed to grades that do not comply
       with AS/NZS 2890.1-2004, Council will require that the driveway be removed and reconstructed to levels
       that do comply.
       Please note, a step between the driveway and the footpath shall be avoided, as it is preferred to have the
       footpath continue at a constant grade to minimise the potential for pedestrians to trip or fall.
16.    To ensure pedestrian safety between vehicles exiting the site and pedestrians on the footpath, the
       driveway and any associated fencing or vegetation near the driveway in Grant Street and at the
       intersection of the rear access driveway and Banksia Avenue shall comply with the minimum sight line
       requirements as defined in AS2890.1, section 3.2.4. The applicant shall demonstrate compliance by
       illustrating these sight lines on the plans submitted for both Operational Works approval and Building
       Works approval.

17.    All vehicles shall enter and leave the site in a forward direction.
Car Parking
18.    Carparking shall be provided within the site generally as shown on drawing number 0703.4 SD.02D dated
       February 2007 by Ian Gorton Design and drawing number 0703.4 SD.04D dated February 2007 by Ian
       Gorton Design, except as modified herein.

19.    A minimum of 4 covered carpark spaces shall be provided on site.

20.    The carparking area shall be designed to comply with the provisions of AS/NZS 2890.1-2004 for user
       class 1A with allowance for vehicles to enter and leave the site in a forward gear and with a minimum
       head clearance (headroom) at any point of 2.2m.

21.    The proposed turning areas adjacent to the proposed level 1 and level 3 garaging shall be sign posted to
       indicate that the area is a “Turning Area Only” and that “No Parking is Permitted”. The type and location of
       the signage shall be clearly shown on any plans submitted for Operational Works – Access and
       Carparking.

22.    All carparking shall be kept, maintained and sign posted in a condition fit for use.




MSOffice c:\docume~1\shesse\locals~1\temp\bcl technologies\easypdf 5\@bcl@d4036265\@[email protected]