Skip to the record
Mmm.. taste the original NoosaWatch™

Original source · versioned page text

Reference Documents - MCU24-0115 [As Published]

of 93

Page text shows just the words. Original shows the document exactly as it was published.

4 Pines Noosa                                                                                         Reference: #1869d1-A
81 Noosa Drive, Noosa Heads QLD                                                                      Date: 20 February 2025
Entertainment Noise Assessment


4 Results and Discussion
 4.1 Summary of findings
 No major acoustical issues were identified during testing.                                          G51 Check Item 47 ☐


 The calculated maximum allowable noise level associated with amplified
 entertainment (with the façade fully closed and entry only via the sound
 lock) is expected to be sufficient to host amplified entertainment at a
 “nightclub” level, during all approved operating times.

 With the façade fully open, the calculated maximum allowable noise level
 associated with amplified entertainment is expected to be sufficient for
 general background music during all approved operating times.

 Due to the amount of urban activity and extraneous noise from traffic,
 pedestrians etc. in the vicinity of the subject site, it may be difficult for the
 licensee to monitor compliance at the CEMLs. It is recommended that
 compliance be monitored primarily at the SPLA.



 4.2 Recommended noise limits
 4.2.1 Close External Monitoring Locations
 Presented below are the summarised noise limits at the CEMLs, based upon the calculations
 provided in Appendix B – Calculation Summaries. The limits presented indicate the calculated
 level limit for the venue operating configuration as described in Section 3.7. Measurements
 should be made at the CEML in either dBA (before 10:00PM) or dBC (after 10:00PM) using
 ‘Fast’ time weighting.

                                  Table 7. Calculated noise limits at the CEMLs
 Venue Configuration     Close external         Limiting                 Maximum noise limit at CEML
                         monitoring location    representative
                         (CEML) [3]             affected premises        Before 6:00PM,    Before               After 10:00PM,
                                                                         dBA [1]           10:00PM, dBA         dBC [2]
                                                                                           [1]

               [a]
 Façade open             CEML-1                 RAP.3                    88                --                   --
                                                RAP.3                    --                65                   --
                                                RAP.3                    --                --                   65
                         CEML-2                 RAP.6                    68                n/a                  n/a
 Façade closed [b]       CEML-1                 RAP.1                    n/a               61                   71
                         CEML-2                 --                       n/a               n/a                  n/a
G51 Check Item 48 ☐
[a]
    Test configuration is shown in Figure 9 and described in detail in Section 3.7.1.
[b]
    Test configuration is shown in Figure 10 and described in detail in Section 3.7.1.
[1]
    Measured in dBA using a ‘Fast’ Time Weighting.
[2]
    Measured in dBC or dBZ using a ‘Fast’ Time Weighting.
[3]
    CEML locations are marked in Figure 6 and photos provided in Appendix D – Detailed Measurement Locations.




Live It Acoustics | Controlled Document v1.0                                                                           Page 22
Log in to download the original file

Reference Documents - MCU24-0115 [As Published].pdf · 4.4 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.