Appendix D Code Assessment · MCU16/0099.01

Division 16 — Existing Services Code
Table 12 Specific outcomes for the existing services code
                  Specific Outcomes                           Probable solutions (if code assessment)                                    Comment

 Setbacks and easements                                     S1.1     The footing of any structure or building      O1 is not applicable
 O1    Development near a sewer, water main,                is located clear of the zone of influence but no       The proposed access and power installation to the
 stormwater drain, overland flow path or                    closer than 1.5m (measured horizontally) from          approved facility are not located near a sewer,
 associated structure does not—                             infrastructure including sewers, water mains and       water main, stormwater drain, or overland flow path
      adversely affect the function of the service;         stormwater structures;                                 identified in O1. The proposed access and power
       place an additional load on the service; and                                                                installation to the approved facility are located on
                                                            AND                                                    rural properties containing natural features such as
       unduly increase future maintenance costs.                                                                   vegetation and a watercourse. Both are located
                                                            S1.2    No building or structure overhangs the         more than 20 m from these services located on or
                                                            zone of influence;                                     adjacent to the existing dwellings of the subject site
                                                            AND                                                    and access lot.

                                                            S1.3     Finished surface levels maintain a
                                                            minimum of 600mm of cover, but no greater
                                                            than 3m of cover to the underground
                                                            infrastructure;

                                                            AND

                                                            S1.4    If the existing surface level is altered,
                                                            surface level services including manholes and
                                                            inspection points are altered to match the new
                                                            surface level;

                                                            AND

                                                            S1.5   Alterations are constructed in
                                                            accordance with Section 4 of PSP5 –
                                                            Engineering Design Standards – Roads,
                                                            Drainage and Earthworks and applicable water
                                                            and sewerage design standards;



                                                                                              Project 226420 File Appendix D – Code Assessment 2019-12-10 Revision 2 Page 51