Decision Notice - 010.2008.00000071.001 [As Published] · 142008.71

NOOSA COUNCIL IDAS Development Application Decision Notice                                                     3 of 7




                                       Noosa Council Conditions
                                       INTEGRATED PLANNING ACT 1997, IDAS DEVELOPMENT APPLICATION


1.     The development shall be carried out in accordance with drawings Nos.

              Proposed Driveway            undated by applicant

              2188.8 – Site Plan           dated 21 September 2007 by Good Building Design

              R-0050-1                     Council’s Standard Drawing

              or as modified herein.

2.     The driveway shall be designed and constructed to Council’s design standards and to grades that prevent
       vehicles from scraping and/or bottoming whilst also allowing pedestrians movements along the footpath
       without any step or level difference. Should any driveways be constructed to grades that do not comply
       with AS2890.1-2004, Council will require that the driveway be removed and reconstructed to levels that do
       comply.
       Please note, a step between the driveway and the footpath shall be avoided, as it is preferred to have the
       footpath continue at a constant grade to minimise the potential for pedestrians to trip or fall.
3.     To ensure pedestrian safety between vehicles exiting the site and pedestrians on the footpath, the
       driveway and any associated fencing or vegetation near the driveway shall comply with the minimum sight
       line requirements as defined in AS2890.1, section 3.2.4.

4.     Suitable sediment control devices ("in pit” pollution control devices) shall be temporarily installed into the
       first existing external downstream stormwater structure.
       These devices are to be checked and cleaned on a regular basis and specifically after each rain event.
       These devices are to remain in place during the civil works and construction phases of the development.
       The location and type of device to be installed shall be established at the “pre start” meeting with
       Council’s Construction Technical Officer and shall be installed prior to the commencement of any works.
5.     A site control bond of $1500 is to be submitted to Council prior to the pre-start meeting. The pre-start
       meeting will only be held once Council's Construction Technical Officer has confirmation that the bond
       monies have been received by Council.

       The bond will be refunded less any costs incurred by Council in ensuring compliance with these
       conditions or any additional inspections incurred for substandard work or work undertaken not in
       accordance with this permit.

6.     Council’s Construction Technical Officer Mick Conroy (ph 0410 512 505), shall be given seven (7) days’
       notice of intention to commence works to arrange a “pre start” meeting regarding the civil works.

7.     The principal contractor must have all the appropriate insurance and public liability documentation to carry
       out the works. The principal contractor is also responsible to ensure that any sub contractors also have
       the appropriate insurance and public liability documentation.

8.     Prior to the “pre start” meeting, the principal contractor must be provided with a copy of Council’s
       signed approved drawings and conditions by the applicant.

9.     Council standards shall apply to these works unless otherwise modified herein.

10.    The person acting on this permit shall ensure that its consultants and contractors take all reasonable care
       during the construction of the engineering works to ensure that Council property, road pavements or
       facilities (such as underground drainage, water supply, sewerage, footpaths, kerbing, landscaping, street
       furniture etc.) are protected against any damage or interference whatsoever.




NSC c:\docume~1\amoore\locals~1\temp\bcl technologies\easypdf 5\@bcl@740560f5\@[email protected]