Skip to the record
The gold standard in government transparency.

Original source · versioned page text

2020-05-18 General Committee Agenda

of 80

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

Text sections have not been matched to the original PDF pages. Use the original document to check page numbers.

GENERAL COMMITTEE MEETING AGENDA                                                        18 MAY 2020




                     Figure 7: Drainage corridor and vegetated buffer to rear of site


2.   ASSESSMENT
2.1. Instruments for Statutory Assessment
Under the Planning Act 2016 the application must be assessed against each of the following
statutory planning instruments to the extent they are relevant to the development:
   State Planning Policy;
   South East Queensland Regional Plan;
   Planning Regulation 2017
   The Noosa Plan.
The proposal is generally consistent with the State Planning Policy, Regional Plan and Planning
Regulation 2017.
The following codes in the Noosa Plan are the applicable benchmarks for this development
proposal:
   Noosaville Locality Code
   Detached House Code
   Natural Hazards Overlay Code (Acid Sulfate Soils)
The subject site is located in the Noosaville Locality and is zoned Industry. An ancillary dwelling
unit is identified as a consistent use with the zone and is required to follow a code assessable
application process.
The pertinent issues arising out of the assessment are discussed below:




                                                                                        Page 58 of 80
Log in to download the original file

2020-05-18 General Committee Agenda(PDF, 9MB).pdf · 9.3 MB (large file)

Large file: the download may take up to a minute.

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.