Referral Agency Response - Planning RAP23 0029 · DBW23/0125

                           Plan No.          Rev.       Plan/Document Name                           Date

                           -                 -          -                                            -

                        The following plans require amendment.

                           Plan No.              Rev.       Plan/Document Name                       Date

                           C1.0                  -          Site Plan prepared by Chris Clout 18.01.2024
                                                            Design

                           C1.2                  -          Ground Floor Plan prepared by Chris 18.01.2024
                                                            Clout Design

                           C1.3                  -          Upper Floor Plan prepared by Chris 18.01.2024
                                                            Clout Design

                           C2.0                  -          Elevations prepared by Chris Clout 18.01.2024
                                                            Design

                           C2.1                  -          Elevations prepared by Chris Clout 18.01.2024
                                                            Design

                           C3.0                  -          Section prepared by Chris Clout Design   18.01.2024

                           C3.1                  -          Section prepared by Christ Clout Design 18.01.2024

                           Amendments            The upper level of the dwelling is to comply with the required 6
                                                 metre building setback, measured from outermost protection.

                                                 The mean height of the built to boundary “services” structure
                                                 (attached to the garage) is to be reduced. The built to boundary
                                                 structure is to achieve compliance with the Queensland
                                                 Development Code A2(d).

                                                 The “outdoor living” area as annotated on the architectural plans
                                                 is to be setback a minimum of 1.5 meters from the northern side
                                                 boundary, the kitchen element where stepped as shown on Plan
                                                 C1.2, dated 07.12.2023, may achieve a 1 metre setback.

                                                 Revised plans removing the below ground storage area as
                                                 shown on Plan C3.0, Section 1, with this area returned to natural
                                                 ground level or otherwise backfilled (where within the property
                                                 boundaries).

                                                 The deck along the rear boundary (where greater than 1 metre
                                                 above natural ground level) is to achieve a setback of 1.5 metres.
                                                 The area been the deck and property boundary is to be returned
                                                 to landscaped area, low profile stairs (where not greater than 1
                                                 metre from natural ground level) are permitted.

                        *(Refer to Advisory Note)
                        Building Height
                 3.     The maximum height of the development must not exceed 8.12 metres above the
                        ground level, where shown on Plan C4.4, prepared by Chris Clout Design.


                                                                                                            Page 2 of 4
Document Set ID: 22947572
Version: 3, Version Date: 17/04/2024