2016-10-17 GC Agenda - Item 8 - Attachment 2 (Amended) - Statement of Financial Position

The bell or chime shall be connected to the public address system so that it is audible to the
passengers. Further operations of the bell pushes shall not ring the driver's audible signal
again until the light and bell circuits have been cancelled and reset by the opening and
closing of a door at the next stop.

Luggage/Storage Provision:

Provision shall be made for a small luggage area above both front wheel arches. This must
comply with Transport Operations Passenger Transport Act (TOPTA).

Rear Vision Mirrors:

Unless an alternative has been agreed between the Lessee and Lessor, the following shall
apply:

    a)    One convex mirror approximately 430 mm x 220 mm shall be installed on the front
         header in such a position that the driver’s view of the passenger saloon is maximised.

    b)    A suitably sized convex mirror shall also be mounted on the rearmost modesty panel
         stanchion above the rear access door of buses. This mirror, in combination with the
         front bulkhead mirror, shall allow the driver to observe passengers in this area.

Interior Lighting:

Interior saloon lights shall LED units and be provided to comply with relevant Acts and
Standards, and positioned so that no lights reflect on the windscreen.

The saloon lighting shall be wired through 2 control switches on the driver's console panel to
provide the following options:

(a) All lights on;

(b) Lights behind driver’s position and ahead of the rear door off; and

(c) All lights off.

A driver operated dimmer control shall be provided and set to control the light output of only
those lights behind the driver’s position and ahead of the rear door.

Two separate ceiling lights shall be mounted above the driver’s position, one to allow the
driver to read whilst seated and the other illuminate the cashbox/cashtray area for fare
collection. The lights shall be controlled by the driver, as well as operating automatically
when the front saloon door is open, when the bus exterior lights are on.

Driver’s Seat:

The driver’s seat shall be high backed and fitted with a head rest. The seat shall be fully
adjustable and equipped with adjustable lumbar support controls. All seat adjustment
controls shall be located on the left hand side of the seat. The seat shall be designed to
ensure comfort for drivers of various weights and heights for continuous driving periods of up
to 5 hours. Driver seat belt is to be fitted to the left hand side of the driver with the buckle on
the right hand side.

Two-way Radio Equipment:




                                                                                                 42