Decision Notice - 010.2007.00001849.001 [As Published] · 142007.1849

NOOSA COUNCIL IDAS Development Application Decision Notice                                                     3 of 7




                                     Noosa Council Conditions
                                     INTEGRATED PLANNING ACT 1997, IDAS DEVELOPMENT APPLICATION


1.     The development shall be carried out in accordance with Engineering drawings Nos.

       070831-01            dated 11 September 2007 by Colin Pywell Pty Ltd
       or as modified herein.

2.     Provide 6 x 45litre Acmena hemilampra street trees within the footpath area along the Laguna Street
       frontage of the site.

3.     Install suitable root barrier where proposed trees are adjacent to paths, pavement etc in accordance with
       Council’s Planning Scheme Policy PSP03 Landscaping Plants and Guidelines.

4.     A footpath 1.5 metres wide shall be constructed between the existing driveway to lot 7 and the new
       driveway to lots 8 & 9. The footpath shall have a slip resistant surface. The alignment, of which, shall be
       determined on site with Council’s Construction Technical Officer. The expansion joints in any
       bikeway/footpath shall be “sawcut” not trowel jointed.

5.     The total required pavement thickness shall be based on the Department of Transport’s Pavement Design
       Manual using soaked CBR tests of the subgrade.

       The design pavement thickness, together with CBR test results shall be submitted to Council’s Manager -
       Land Development for approval prior to placement of pavement material.

6.     Suitable sediment control devices ("in pit” pollution control devices) shall be temporarily installed into the
       first existing external downstream stormwater structure.
       These devices are to be checked and cleaned on a regular basis and specifically after each rain event.
       These devices are to remain in place during the civil works and construction phases of the development.
       The location and type of device to be installed shall be established at the “pre start” meeting with
       Council’s Construction Technical Officer and shall be installed prior to the commencement of any works.
7.     Council’s Construction Technical Officer – Mick Conroy (ph 0410 512 505), shall be given seven (7) days’
       notice of intention to commence works to arrange a “pre start” meeting regarding the civil works.

8.     The principal contractor must have all the appropriate insurance and public liability documentation to carry
       out the works. The principal contractor is also responsible to ensure that any sub contractors also have
       the appropriate insurance and public liability documentation.

9.     Prior to the “pre start” meeting, the principal contractor must be provided with a copy of Council’s
       signed approved drawings and conditions by the applicant.

10.    The Consulting Engineers for the project shall be currently Registered Professional Engineers of
       Queensland (RPEQ). The consulting engineers are responsible for arranging all inspections, with
       Council’s Construction Technical Officer or nominated staff.       The works will be accepted “On
       Maintenance” after this form, signed by the inspector for each stage is complete, together with a letter
       from the Engineer requesting that the works go “On Maintenance”.

11.    Prior to works commencing, Council is to be advised of the Engineer (RPEQ) supervising the project.
       (This person will be the contact for the project).

12.    An inspection is to be carried out with the relevant Council officers, the Contractor and Supervising
       Engineer after road centrelines have been established, and prior to clearing being carried out. This
       inspection is to deal with the limits of clearing to be carried out for this development. This meeting is to
       take place prior to the “Pre-start” meeting.

13.    Council standards shall apply to these works unless otherwise modified herein.




NSC c:\docume~1\rhr\locals~1\temp\bcl technologies\easypdf 5\@bcl@a4017bc0\@[email protected]