Skip to the record
The gold standard in government transparency.

Original source · versioned page text

Combined Approved Plans RAL21/0003

of 115

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

Very large file: it may take a few minutes

The original of this document is very large (12.4 MB). Opening the original or downloading it may take a few minutes. Please be patient and don't click again. The page text is quick to read. If you are on mobile data, it is best to wait until you are on Wi-Fi.

Plans and drawings

This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).

Log in to see the plans as drawn
                Total Concept Homes                                                                                        20332-001-Rev1
                                                                                                                            22 March 2021

                2.0       DESCRIPTION OF EXISTING CONDITIONS
                2.1     Geology and Subsurface Conditions
                The 1:100,000 scale Gympie Special Geological Map 1 (Ref. Text Figure 3 below) indicates that the site is
                underlain by materials derived of the early to middle Triassic age Kin Kin Beds (pale green blue shading),
                which are described as “arenite, argillite and phyllite.”




                                                                         Approx. site location




                Text Figure 3: Extract of Gympie Special Geology Map
                The Ground Drill investigation comprised drilling of two boreholes (designated BH1 and BH2) to the north
                and south of the approximate proposed residence on the future divided allotment, with an additional borehole
                (denoted borehole BH6) drilled to capture part of the driveway alignment to the east. Boreholes BH1 and
                BH2 were terminated in the underlying weathered rock at a target depth of 2 m below ground level (BGL);
                with borehole BH6 extending to auger drilling refusal at 2.5 m BGL.
                Additional shallow boreholes were also drilled to the east of the prosed residence on the future allotment, to
                provide information for the on-site effluent disposal design. These were taken to a target depth of 1.5 m BGL.
                All boreholes were drilled using a 4WD utility mounted drill rig, with solid flight augering equipment. In situ
                strength testing comprised the dynamic cone penetrometer (DCP) method, taken from surface adjacent and
                at selected depths downhole.
                The subsurface profile logged in each of the boreholes was relatively consistent, and comprised the profile
                indicated on the following page:




                1
                 State of Queensland, Department of Mines and Energy, Nambour Special 1:100,000 Geological Series, Sheet 9445 and Part 9545,
                First Edition 1999




                                                                              3/14
Document Set ID: 21426326
Version: 1, Version Date: 24/03/2021
Log in to download the original file

Combined Approved Plans RAL21_0003.pdf · 12.4 MB (very large file)

Very large file: the download may take a few minutes. If you are on mobile data, it is best to wait until you are on Wi-Fi.

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.