Skip to the record
Accept no substitutions.

Original source · versioned page text

Combined Approved Plans RAL21/0003

of 115

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

Very large file: it may take a few minutes

The original of this document is very large (12.4 MB). Opening the original or downloading it may take a few minutes. Please be patient and don't click again. The page text is quick to read. If you are on mobile data, it is best to wait until you are on Wi-Fi.

Plans and drawings

This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).

Log in to see the plans as drawn
                Total Concept Homes                                                                                20332-001-Rev1
                                                                                                                    22 March 2021

                          An upper layer of residual, medium plasticity, stiff silty clays to between 0.6 m and 0.7 m BGL;
                           overlying;
                          Extremely weathered (XW) material comprising stiff to very stiff silty clays, to between 1 m and
                           1.4 m BGL; then grading to
                          Weathered Phyllite, inferred to be very low to low strength to the borehole termination/target
                           depths.

                Groundwater seepage was not encountered during the drilling of either borehole BH1 or BH2, with all
                soils being described as “dry.”
                The site was classified by Ground Drill as Class P in accordance with AS2870-2011 due to the presence
                of mature trees. In not for this factor the site would have been classified Class M with characteristic
                surface movements (ys) of up to 35 mm reported by Ground Drill.

                Along the southern edge of the existing access track, and in the cutting behind the existing residence
                exposures of weathered rock were observed. These were noted to consist of moderately weathered, very
                low to low strength, pale yellow brown phyllite; which had a well developed foliated fabric. To the south-
                east of the existing residence this was interlayered with XW materials, although the lateral extent of this
                was not clear, and such materials may be restricted to the near-surface of the exposed rock mass.

                A view of the exposed weathered rock above the highest section of proposed earthworks filling is shown
                below in Text Figure 4.




                Text Figure 4: Exposed weathered phyllite in cutting above highest section of earthworks filling

                2.2       Topography
                As illustrated in Text Figure 5 on the following page, the wider area around the site consists of a series of
                approximately parallel ridgelines and gullies, aligned east-west. The ridgelines within the subject allotment
                lead east from Black Mountain Range Road, which traces a crest forming a drainage divide between
                eastward and westward draining creek lines.

                Just off Black Mountain Range Road, to the south-west of the overall existing allotment, a rounded gully
                head was present, with sideslopes ranging from about 25° (47 %) at the site entrance to between 15° and
                20° (27 % and 36 %) nearer the existing residence. Minor existing cut and fill earthworks had been
                undertaken sidelong to the slope to facilitate the existing track, being 1 m to 1.5 m depth and around 1 m
                height respectively. Below the existing residence, to the north, a series of cut terraces had been formed for
                horticultural purposes. These were in the order of 2.5 m width, with cut batters of around 0.6 m depth or less.
                Across the existing earthworks features on site, no signs of significant slumping were observed.




                                                                            4/14
Document Set ID: 21426326
Version: 1, Version Date: 24/03/2021
Log in to download the original file

Combined Approved Plans RAL21_0003.pdf · 12.4 MB (very large file)

Very large file: the download may take a few minutes. If you are on mobile data, it is best to wait until you are on Wi-Fi.

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.