2016-10-20 Ordinary Meeting Minutes

ORDINARY MEETING AGENDA                                                     20 OCTOBER 2016


          Assessment dated 10 October 2016 prepared by RoadPro Acoustic. The amended
          Noise Management Plan must be submitted to Council prior to the commencement of
          the use.
    8.    Noise emissions from any new mechanical equipment associated with the
          development must comply with the following requirements:
          a.    Air-conditioning and Refrigeration
                    7am to 10pm: Background + 5dB(A)
                    10pm to 7am: Background + 3dB(A)
    9.    Written certification must be submitted from a suitably qualified person confirming
          noise levels from any new mechanical equipment comply when measured at either
          the residential boundary or outside the most exposed part of an affected building,
          whichever is the closest to the equipment.
          The assessment and certification is required immediately after installation of the
          equipment and in a format approved by Council. All equipment should be operating at
          the same time to test the overall noise level created.
    Advice: It is highly recommended the person you engage to certify the installation is
    involved prior to installation of any equipment so they can recommend where equipment is
    best located. They can also advise about noise enclosures and make other suggestions to
    avoid noise problems. It is a lot more costly to try and deal with noise problems after
    installation.
    Nature and Extent of Approved Use
    10.   The approved use must not operate outside the hours of:
          a.    6.30am to 9.30pm Monday Sunday to Thursday
          ab.   6.30am to 10.30pm Friday, Saturday and public holidays
          bc.   The outdoor dining area must not be used after 8pm until the acoustic wing
                walls are installed pursuant to the recommendations of the Acoustic
                Assessment dated 3 August 2016 and Additional Information dated 10 October
                2016 prepared by RoadPro Acoustic.
    4.    Service vehicle movements associated with the approved use (including loading and
          unloading) must not occur outside the hours of 7am to 6pm Monday to Saturday and
          not at all on Sundays or public holidays.
    5.    The use area including outdoor seating must not exceed 67m2 as indicated on the
          approved plan.
    Protection of Privacy
    6.    To ensure privacy is protected between adjoining properties, the western acoustical
          designed wing wall must be designed to maintain privacy of the neighbouring unit. In
          this regard, the wall must be either translucent glazing or a solid portion to obscure
          direct views to the western unit.
    Outdoor Lighting Devices
    7.    Light spillage from the development including advertising, security and flood lighting
          etc is designed, sited, installed, shaded and appropriately directed so as to prevent a
          nuisance to residential areas and vehicular traffic.
    Kitchen Exhaust
    8.    Kitchen exhaust points for the development must be located and operated in
          accordance with Australian Standard AS1668.2-2002 “The use of ventilation and air-
          conditioning in buildings” (specifically Section 5.10 – Air Discharges).


                                                                                  Page 15 of 18