2017-01-16 General Committee Agenda

GENERAL COMMITTEE MEETING AGENDA                                                  16 JANUARY 2017


      41.   Where landscaping/garden beds are proposed adjacent to the bioretention basin, or
            where the basin is located adjacent to naturally forested areas, a 900mm deep root
            barrier must be installed to the interface between the landscape/garden/forest area and
            the bioretention basin to prevent root intrusion to the biobasin infrastructure.
      42.   Where required, mulch within the batters of bioretention basins must be installed in a
            manner that it will not escape into receiving stormwater drainage infrastructure or water
            courses.
            Bioretention Devices - Education
      43.   The development must provide approved permanent signage to educate the public on
            the function of the bioretention basin. The wording for the signage for each bioretention
            basin is to include: “BIORETENTION BASIN - This bioretention basin reduces the
            pollution of our waterways by reducing the amount of heavy metals, litter, suspended
            solids, and nutrients discharged to Eenie Creek”.
            FOLLOWING CONSTRUCTION
            Certification
      44.   Upon completion of the work and prior to the final inspection a certificate must be
            issued by an RPEQ certifying that the works have been constructed in accordance with
            the Operational Works permit and applicable engineering standards.
      45.   A final inspection and approval of the completed works by Council’s Inspector is
            required. Please contact Council on 5329 6291 to arrange for the inspection.
B.    Find that the tasting room and associated kitchen and preparation area is ancillary and
      complementary to the primary industrial use on-site and will not cause any reverse amenity
      issues and therefore is sufficient grounds to justify the decision despite the conflict with the
      Planning Scheme.




REPORT
1.    PROPOSAL
The application seeks approval for Industrial Business Type 2 being for a brewery of alcoholic
beverages and Entertainment and Dining Business Type 1 food and beverage for an ancillary
product tasting room and associated kitchen.
The built form consists of tilt panel construction with a colorbond roof, extended awnings and
eaves. The brewing vats are proposed to be seen from the street through glazing and a defined
covered entry located to the southern side of the building incorporates a variety of material finishes.
Figure 1 below shows perspectives of the proposal.




                                                                                      Page 39 of 146