Skip to the record
NoosaWatch™: The source of truth.

Council archive · source document

10/0515 - Lot reconfiguration (4 to 2) [As Published] · 152010.515

of 68

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

REI RT

 

 

 

 

b) provides a high level of internal accessibility both within
the site and to external sites and appropriate external
connections for vehicles, pedestrian and cycle movements;
¢) deters through-traffic from residential areas and creates
safe conditions for local road users, pedestrians and
cyclists;

d) incorporates street junctions and access to lots that are

‘| located and spaced to facilitate safe and convenient vehicle

movements; optimise the cost effectiveness of the network
and the provision of public utilities;

f) provides for road reserve widths not less than the
minimum identified Section 2.3 of PSP5 Engineering
Design Standards — Roads, Drainage.and Earthworks;

sympathetic to the terrain;

h) has no significant adverse effects on habitat corridors or
areas of significant native vegetation;

i) does not create noise attenuation difficulties;

j) incorporates pedestrian and cyclist crossings at
intersections or where required to access high activity
nodes and public transport;

k) has regard to the potential for conflict between vehicles,
pedestrians and cyclists; and

'l) incorporates on-road cycling facilities.

“e) provides for street widths and lengths that

 

 

g) minimises the extent of earthworks required by being’

‘| e) shared parking / bicycle lane;

 

with, in order of precedence—
a) Noosa Integrated Local Transport Plan;

b) Queensland Transport’s Shaping Up

c) Queensland Design Code for Residential Streets;

d) AUSTROADS Guide to Traffic Engineering Practice;

e) Sections 2 and 3 of PSP5 Engineering

Design Standards- Roads, Drainage and Earthworks;

f) The Noosa Cycling and Walking Network Development Plan;
or

g) Acombination of the principles in these documents; AND
$7.3 The achievement of multiple connections for all roads and
streets (excluding culs-de-sac) within the subdivision and to
adjoining subdivisions;AND

$7.4 Road networks provide connectivity between residential
areas, both internally and to adjoining sites, using access roads
AND

$7.5 The length of a cul-de-sac does not exceed 200m in urban
areas and 500m in rural areas; AND

$7.6 The ‘layout uses street and road design, including
variations in carriageway width, as a traffic calming measure to
encourage lower traffic speeds. (Note: Carriageway widths are
identified in Section 2.3 of PSP5 Engineering Design Standards
— Roads, Drainage and Earthworks.) AND

$7.7 On-road cycling treatment is utilised

to provide safe and continuous movement of cyclists along a
Toadway such as--

a) sealed shoulders;

b) wide kerbside lane;

c) exclusive or peak period bicycle lane;

d) advisory treatments such as Bicycle Awareness Zone;

f) contra flow bicycle lane; or
g) bus/bicycle lane; AND
$7.8 The provision of bicycle lanes at intersections is generally
in accordance with AUSTROADS Part 14, section 5 and Manual
of Uniform Traffic Control Devices (MUTCD) Part 9.

 

 

 

[08 The development contains a pathway system that

 

 

$8.1 Subdivision design and layout provides for walking and { Not Applicable

 

 

CadCon Surveying & Town Planning :

= > Page 3of41

    

Used in these records

About this file

File size
4.4 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

10_0515 - Lot reconfiguration (4 to 2) [As Published].pdf · 4.4 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.