2014-06-26 Ordinary Meeting Agenda

ORDINARY MEETING AGENDA                                                           26 JUNE 2014


    42.   Draft easement documentation must be submitted to Council for endorsement.
    43.   All works must be kept clear of any existing or proposed easements on the subject
          land, unless agreed otherwise in writing by the Grantee.
    Earthworks and Retaining Walls
    44.   All fill and associated batters must be must be undertaken in accordance with an
          Operational Works approval, and contained entirely within the subject site unless
          written permission from the respective landowner(s) is provided to Council.
    Damage to Services and Assets
    45.   Any damage caused to existing services and assets above or below the ground must
          be repaired:
          (a)   where the damage would cause a hazard to pedestrian or vehicle safety,
                immediately; or
          (b)   where otherwise, upon completion of the works associated with the
                development.
          (c)   Any repair work which proposes to alter the alignment or level of existing
                services and assets must first be referred to the relevant service authority for
                approval.
    UNITYWATER
    Water and Sewerage
    46.   The fire-fighting demand on Unitywater’s water supply system from the development
          must not exceed 30 litres per second.
    47.   A single Unitywater installed primary water meter must be provided immediately
          inside the property boundary. Additional water meters must be installed for each title
          of a community title or sub-lease scheme. Meters must be Unitywater approved,
          installed in accordance with Unitywater standards and requirements and remain
          accessible at all times for reading and maintenance purposes.
    48.   Water meters must be located on alternative boundaries to electrical pillars.
    49.   Buildings and other structures must maintain a minimum clearance of 1.5 metres
          from Unitywater sewer mains, and 1.0 metre from sewer manhole chambers and
          inspection openings.
    50.   The applicant must adjust the level of the existing sewerage inspection opening as
          necessary to suit the proposed finished levels. Work must be undertaken by
          Unitywater at the owner’s cost. Where the existing sewerage inspection opening point
          is located within a sealed or concreted area, a brass cap is required to be fitted.
    51.   Storm water retention systems and gross pollutant traps must maintain a minimum
          clearance of 1.5 metres from Unitywater water supply and sewerage infrastructure.
    52.   Redundant sewer pipes within the development site must be removed or slurry filled.
    53.   Tree plantings must maintain a minimum horizontal clearance of 1.0 metre from
          Unitywater water mains and 1.5 metres from Unitywater sewerage mains.
          Landscaping plants within these clearances must be low growing when mature and
          suitable approved varieties.
    54.   Construction works undertaken in the vicinity of Unitywater water supply or sewerage
          infrastructure must not adversely affect the integrity of the infrastructure. All costs
          associated with repair, replacement or alteration of infrastructure must be met by the
          applicant.



                                                                                  Page 24 of 34