Development Application Part 1 of 2 - IDAS Form 1, Form 28, Checklist, vica versa doc details of attachment 13 Cooran Court Noosa Heads · OPW10/2100

INSTRUCTION MANUAL

 

> Begin by laying the dock sections out with the bow floats
and one mid section so that the 2 and 3 tabs on the bow
floats are set to insert into the mid section 1 and 4.

Vv

Continue setting out the remainder of the dock sections
in the same order. The end result will look something like
the picture shown at left.

Vv

Beginning at the bow, slowly bring the section together
so that the 1 tab on the mid section is below the 2 tab on
the bow section.

> When the tabs are in line, slip a connecting pin or lug bolt
connecter in the side to hold the sections.

NOTE: In most PWC and Boat docks, the center channel is
designed to use the white bolts instead of the connecting
pins. VersaDock uses both configurations depending on your
particular need and use. If your dock is shipped with the lug
bolts, simply use them in place of the grey connecting pins in
the following instructions.

In almost every case, the bow section and the first mid sec-
tion will be connected in the center channel with grey con-
necting pins.

 

PWC dock (PWC-152) with lugs down the middle
Notice the single floats at the 3rd from the stern—this is necessary
for easy driveon—doubles next to the stern are too bouyant

>

As shown at right, slide the sections together so
that the 2/3 tabs go between the 1/4 sections.

> When the dock sections are together, insert the 2
connecting pins or lug bolts in the holes and tighten.

 

Connecting the sections using the “Hinge Pin”