Skip to the record
Noosa's #1 Council Tracker.

Council archive · source document

0015584F.001

of 69

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Text sections not matched to the original PDF pages. See original document to check page numbers.

r      .   Project No. 306-2474
           November, 2006                                                                         Page 6
                                                                 eee                                IE
                 *   Imported select fill material, if required, should be a good quality select fill material
                    with a soaked CBR >10% and a maximum aggregate size of 75mm.
                 *   Fill placed in the area of the building should be compacted in layers (approximately
                    200mm loose thickness) to a density not less than 95% of maximum dry density in
                    accordance with AS 1289 5.1.1 (Standard Compaction).
                 *  Field density testing should be carried out to check the standard of compaction
                    achieved and the placement moisture content. The frequency and extent of testing
                    should be as per guidelines in AS.3798-1996, Section 8.0.
               The soils encountered on site {to borehole depth) should be within the excavation limits
               of a small dozer (eg. Cat D4 or similar) in bulk earthworks and a medium sized backhoe
               (eg. Case 580 or similar) in trench excavations.
©           6.3   Excavation Stability
               The following general recommendations are made for short term stability of batters for
               bulk excavation of the site.
                *  Batter angle not greater than 1V:2.5H above the horizontal.
                *  Top of batter to be a minimum of 2.0m inside any boundary line, in addition to 3.0
                   metres distance from any building or structure.
                *  If batters are to be left untreated for any length of time, a batter angle of 1V:4H is
                   recommended and berm width are to be strictly maintained.

           6.4   Building [email protected].  Site Classification
              While a site classification in accordance with AS.2870 ‘Residential Slabs and Footings'
              relates to residential type construction and is not directly applicable for this development,
              itis, however, a valuable method of classification.
              Given the investigation drilling encountered Sandy soils only, which are non-reactive to
              variations in soil moisture, the site could be classified as “Type A” in accordance with
              AS.2870 ‘Residential Slabs and Footings’. While no surface movement would be
              expected due to changes in moisture, some settlements may occur in the upper very
              loose to loose sand due to vibration induced compaction (construction activities, vehicle
              movements, etc.).

            TT                                                        eee
                                                                 YF SOIL SURVEYS ENGINEERING

Used in these records

About this file

File size
4.1 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

0015584F.001.pdf · 4.1 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.